EverFocus ENQ2200 User Manual page 20

All manuals and user guides at all-guides.com
Password: Input the password if the SMTP server requires authentication.
Receiver Address: Input the e-mail address to receive an e-mail message when
the EVENT is enabled and triggered. Please use "; " to separate address.
ddress: Input sender's e-mail address, so that receiver can recognize
Sender A
th e sender when an event message is sent out.
Press
Send Test Mail:
address.
Set FTP
The settings relating to an FTP server to be used to receive alarm images can be
configured.
FTP Server: Enter the IP address or the host name of the FTP server.
FTP Port: Enter the port number for FTP server. Default is 21.
Recording Path: Assign the recording path.
User Name: Set FTP User name.
Set FTP password.
Password:
PASV mode: Check to enable Passive mode (most sites normally require Passive
mode). If unable to establish a connection, uncheck "PASV" mo
Test FTP Server: Press
FTP server.
Press Apply to apply the setting changes or Reset to reset without saving the
change.
button to send a test e-mail to the designated
button to send a test file to the designated
20
EQN2200/2201
de.