Section 6.4 | Configuration For Wired Operation Via Tv User Interface - SMC Networks SMCWMR-AG User Manual

i) Once the SMCWMR-AG is connected, it will ask you to [Register Now].
This will give you the option to upgrade your firmware via Smart Box
Management to take advantage of new updates. (Note: You can
register at any point by going to the [Settings] menu)

Section 6.4 | Configuration for Wired Operation via TV User Interface

Note: You will need your SMCWMR-AG Universal Wireless Multimedia Receiver
Remote Control if you wish to make changes to the default settings.
Step 1: Turn on the SMCWMR-AG. By default, the SMCWMR-AG Universal
Wireless Multimedia Receiver will be configured to connect to your SMC2804WBR
Barricade g 2.4GHz 54Mbps Wireless Broadband Router and SMC2304WBR-AG
EZ-Stream Universal Wireless Broadband Router. The default settings are as
follows:
• SSID – "SMC"
• WEP – Disabled
• Internet Proxy – Disabled
• IP Address – 192.168.2.45
• Mode – Infrastructure
Step 2: If your network is not configured as specified in Step 1, you will need to
configure the SMCWMR-AG to properly establish a connection to your wired
network.
Step 3: The SMCWMR-AG will automatically ask you to reconfigure your settings
if it was not able to get connected with the default settings.
Step 4: Please answer the on-screen questions to complete the setup.
a) "Network Interface" – Select [Use Wired (Ethernet)] to use a wired
network. Remember, to make a selection, press the [OK] button on
your remote control.
b) "DHCP server present?" – Select [Yes] if you have a DHCP server on
your network that will allow the SMCWMR-AG to obtain an IP address
automatically. If you do not have a DHCP server on your network,
select [No] and input your IP, Subnet Mask, and Gateway addresses.