Section 6.2 | Setting Up The Remote Control - SMC Networks SMCWMR-AG User Manual

Section 6.2 | Setting up the Remote Control

Step 1: Open the battery cover on the back of the SMCWMR-AG Universal
Wireless Multimedia Receiver Remote Control.
Step 2: Insert two AA batteries (supplied) by matching the + and – on the
batteries, with the diagram inside the battery compartment.
Section 6.3 | Configuration for Wireless Operation via TV User
Interface
Note: You will need your SMCWMR-AG Universal Wireless Multimedia Receiver
Remote Control if you wish to make changes to the default settings.
Step 1: Turn on the SMCWMR-AG. By default, the SMCWMR-AG Universal
Wireless Multimedia Receiver will be configured to connect to your SMC2804WBR
Barricade g 2.4GHz 54Mbps Wireless Broadband Router and SMC2304WBR-AG
EZ-Stream Universal Wireless Broadband Router. The default settings are as
follows:
• SSID – "SMC"
• WEP – Disabled
• Internet Proxy – Disabled
• IP Address – 192.168.2.45
• Mode – Infrastructure
Step 2: If your network is not configured as specified in Step 1, you will need to
configure the SMCWMR-AG to properly establish a connection to your wireless
network.
Step 3: The SMCWMR-AG will automatically ask you to reconfigure your settings
if it was not able to get connected with the default settings.
Step 4: Please answer the on-screen questions to complete the setup.
a) "Network Interface" – Select [Use Wireless (802.11)] to use a wireless
network. Remember, to make a selection, press the [OK] button on
your remote control.
b) You will then be asked to input the SSID of your wireless network. Use
the Up/Down arrows on your remote control to choose the appropriate
letters. Use the Left/Right arrows to skip to the next letter of the SSID.
Press [OK] on your remote control when finished.