Table of Contents
Advertisement
Callouts
A
B
C
D
Component
USB port (J1)
Annunciator Selection (SW9)
Address Setting (SW10)
page 6
Figure 3: USB Location and PCB View
Description
Screw locations
USB location
SW10
SW9
Table 2: Remote annunciator main back components
Description
Use for firmware configuration. To access the USB port, remove the back plate. For more information
contact technical support.
Use this switch to select the annunciator and respective firmware configuration.
Use to configure the annunciator address using the DIP switch.
(Hard Addressing)
Foundation Series 2606-9111 LED Annunciator Installation Guide
579-1435 Rev B
Advertisement
Table of Contents
