Black & Decker KC9006 Manual page 6

E N G L I S H
General
1. Keep work area clean
Cluttered areas and benches
can cause accidents.
2. Consider work area
environment
Do not expose the tool to rain.
Do not use the tool in damp
or wet conditions. Keep the
work area well lit. Do not use
the tool where there is a risk of
causing fire or explosion, e.g.
in the presence of flammable
lixWids and gases.
3. Keep children away
Do not allow children, visitors
or animals to come near the
work area or to touch the tool.
4. Dress properly
Do not wear loose clothing or
jewellery, as these can be
caught in moving parts.
Preferably wear rubber gloves
and non-slip footwear when
working outdoors. Wear
protective hair covering to
keep long hair out of the way.
5. Personal protection
Always use safety glasses.
Use a face or dust mask
whenever the operations may
produce dust or flying
particles. Wear ear protection
whenever the sound level
seems uncomfortable.
6. Do not overreach
Keep proper footing and
balance at all times.
7. Stay alert
Watch what you are doing.
Use common sense. Do not
operate the tool when you
are tired.
8. Secure workpiece
Use clamps or a vice to hold
the workpiece. It is safer and
it frees both hands to operate
the tool.
9. Use appropriate tool
The intended use is described
in this instruction manual.
6
KC9006EUR.PM65
Do not force small tools or
attachments to do the job of
a heavy-duty tool. The tool
will do the job better and
safer at the rate for which it
was intended. Do not force
the tool.
Warning! The use of any
accessory or attachment or
performance of any operation
with this tool other than those
recommended in this
instruction manual may present
a risk of personal injury.
10. Check for damaged parts
Before use, carefully check
the tool for damage. Check
for misalignment and seizure
of moving parts, breakage of
parts, damage to guards and
switches and any other
conditions that may affect its
operation. Ensure that the
tool will operate properly and
perform its intended function.
Do not use the tool if any part
is damaged or defective.
Do not use the tool if the
switch does not turn it on and
off. Have any damaged or
defective parts repaired or
replaced by an authorised
repair agent. Never attempt
any repairs yourself.
11. Avoid unintentional starting
Do not carry the tool with a
finger on the on/off switch.
12. Store idle tools
When not in use, tools and
batteries should be stored in
a dry, locked up or high
place, out of reach of
children.
13. Maintain tools with care
Keep cutting tools sharp and
clean for better and safer
performance. Follow the
instructions for maintenance
and changing accessories.
Keep handles and switches
dry, clean and free from oil
and grease.
6 26-07-2001, 11:37