Precautions For Use - Haier ES8V-Q1(EU) Instruction Manual

Hide thumbs Also See for ES8V-Q1(EU):
Table of Contents

Advertisement

Use

Precautions for use

If water heater is not use in long term, close the tap water valve and open the
handle of the safety valve to discharge water from the inner pot. The specific
method is as followings:
ES8/10/15/30V-Q1(R): Turn the mixing valve to the gear for maximum hot
water output, then open the handle of the safety valve to discharge water from
the water outlet pipe of the safety valve.
ES8/10/15V-Q2(R): Dismantle water heater from the pipeline, then turn over
the water heater and make the water pipe port downward to drain water from
the hot water outlet (This operation is rather complicated, please contact our
after-sales department for assistance). Before reusing, it is suggested to open
the hot water valve before turning on the power switch of the water heater to
avoid injuries or other accidents. Do not allow smoking and other open fire
around the opened valve. Meanwhile, check carefully if each component of
the water heater is in good condition and then put in it into use after confirming
that the inner pot is water filled.
Notes:The water outlet pipe port shall not be higher than the pressure relief
hole of the safety valve, and the water outlet pipe shall be inserted into a
position such as floor drain where water can be drained easily.
Adjust the set temperature to the lowest value under the condition that the hot
water is sufficient, thus to reduce heat radiation and high temperature
corrosion and deposit to prolong the life span of water heater.
Safety inspection shall be carried out regularly by service staff. Clean off
incrustation scale in the heating tube timely. Check the wearing of the anode
rod and replace it when there is an excessive loss.
Friendly tips: This product belongs to the small capacity water heater. Do not
tune the outflow rate to the maximum when using. Tune the opening valve to
the minimum as possible as you can (When the tap water pressure is too big,
the heat and cold exchange in the inner pot will accelerate and finally affect
the hot water outflow amount) to ensure more hot water supply.
10

Advertisement

Table of Contents
loading

Table of Contents