Table of Contents
Advertisement
Quick Links
3 Button Remote Security System with Starter Disable
IMPORTANT ! In order to provide the highest possible level of security to your vehicle, this
system is equipped with selectable manual override circuitry. It is possible that you will need to
manually override your security system if the transmitter becomes lost, or inoperative due to
battery failure. Reading the sections on "MANUALLY OVERRIDING YOUR SYSTEM" is
necessary to fully understand the procedure required to enable your vehicle in such situa-
tions. In addition, the chart on the last page of this manual has a section for the particular
features and options installed in your vehicle as well as the override method selected. Valet
Switch manual override is pre-selected from the factory, however, the system can be
configured for "Custom Code" operation. Confirm the override mode selected on the last page
of this manual and familiarize yourself with the section on it's operation.
FEATURES :
2 Three Button Programmable RF Transmitters
Separate Lock/Unlock Transmitter Buttons
Five Channel Receiver (capable of accepting 4 transmitters)
Code Hopping Technology
Selectable Manual Override Mode
Remote Panic in all modes (Improved)
Protected Valet
User Programmable Manual Override Code
7 Function LED - Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / Valet / Arming
Intrusion Alert with Memory
Audible Arm / Disarm / Defective Zone / Tamper Confirmation
True Last Door Arming ( hardwire only )
Defective Zone By-Pass
Hardwire or Voltage Sense Selectable
Active or Passive Arming Selectable
Smart Disarming
Programmable Auto Lock On / Off
Programmable Auto Unlock On / Off
Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds/1 Sec L/ Dbl. U/L
Programmable Active or Passive Door Locks
User Programmable Permanent Chirp Delete
On Command RF Chirp Delete from Transmitter Or Selectable Through Software
Car Horn Activation for alarm response
Additional Negative Trigger Input
RF Inhibit with ignition on
Parking Light Flasher
OPTIONS :
6 Tone Multi-Tone Siren
Remote Trunk Release ( must have electronic trunk release )
Remote Keyless Entry ( must have power door locks )
Illuminated Entry
Multiple Vehicle Capable
Headlight Illumination during Arming and or Disarming
Remote Starter
Remote Power Window Roll Up
Remote Garage Door Interface
Plug In Electronic Shock Sensor
Interior Illumination Upon Disarm
Model PRO 9644N
Owner's Manual
Page 1
128-8500
1 of 12
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for PURSUIT PRO 9644N
Summary of Contents for PURSUIT PRO 9644N
- Page 1 Model PRO 9644N Owner’s Manual 3 Button Remote Security System with Starter Disable IMPORTANT ! In order to provide the highest possible level of security to your vehicle, this system is equipped with selectable manual override circuitry. It is possible that you will need to manually override your security system if the transmitter becomes lost, or inoperative due to battery failure.
-
Page 2: Your " Code Hopping " Transmitters
YOUR " CODE HOPPING " TRANSMITTERS The transmitters included with your new security system use the most advanced and secure form of radio frequency transmission available on any current automotive security system. Some of today’s sophisticated auto thieves use a device known as a code grabber, which will receive and store the signal from your keychain transmitter, and re-transmit at a later time to disarm your system. -
Page 3: Arming The System - Passive ( Automatic )
2. Press and hold the Lock button on the keychain transmitter for 2 seconds. Red dash mounted LED begins to flash slowly. Parking Lights flash one time. Siren will not sound. If the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the system detected a open entry point after the learned delay expired. -
Page 4: Disarming The System
bulb, and will not cause the vehicle’s battery to drain, even when left unattended for extended periods. Whenever the system is triggered, the vehicle’s parking lights will flash for the full 30 second alarm cycle, attracting visual attention to the vehicle. Whenever the system is triggered, the vehicle’s horn will beep for the full 30 second alarm cycle, attracting added attention to the vehicle. -
Page 5: Silent Disarming
Courtesy Lights - Optional Interior courtesy lights turn on for 30 seconds, or until the ignition key is switched on. SILENT DISARMING 1. As you approach the vehicle, press and hold the Unlock button on the keychain transmitter for 2 seconds. Red dash mounted LED turns off. -
Page 6: Intrusion Warning Signals
INTRUSION WARNING SIGNALS This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If an intrusion attempt has occurred, the siren will chirp 4 times and the parking lights will flash 3 times when disarming the system. Enter the vehicle, and observe the red dash mounted LED to identify which zone was triggered. - Page 7 factory with a pre-programmed override code of 11. To change this default override code, do the following: 1. Disarm the system by use of the transmitter, or by use of the emergency override sequence. Turn the ignition switch to the on position. 2.
-
Page 8: Eliminating The Normal Arm/Disarm Chirps
MANUALLY OVERRIDING YOUR SYSTEM: USING THE CUSTOM CODE OVERRIDE Assuming the override code programmed has not been changed, and the default override code of 11 is in the system's memory. 1) Enter the vehicle and turn the ignition switch to the on position. NOTE: The siren will sound. - Page 9 Remote Electric Trunk Release Remote Car Starter Remote Window Closure Remote Garage Door Interface NOTE: In addition there may be a second optional feature connected to your system that when the same transmitter button is pressed and released 2 times within 3 seconds (double pressed), the second optional feature will activate.
- Page 10 PRO 9644N SYSTEM FUNCTIONS AT A GLANCE DASH LED INDICATORS RAPID FLASHING = PASSIVE ARMING SLOW FLASHING = ARMED DISARMED ON SOLID VALET MODE 3 FLASH...PAUSE = INTRUSION ZONE 3 2 FLASH...PAUSE = INTRUSION ZONE 2 1 FLASH...PAUSE = INTRUSION ZONE 1...
- Page 11 THIS PAGE LEFT BLANK INTENTIONALLY Page 11 128-8500 11 of 12...
- Page 12 © 2008 Audiovox Electronics Corporation, Hauppauge, N.Y. 11788 128-8500 Page 12 128-8500 12 of 12...
Need help?
Do you have a question about the PRO 9644N and is the answer not in the manual?
Questions and answers