5 button remote start security system with plug-in shock sensor & starter disable (13 pages)
Summary of Contents for PURSUIT PR5BZ
Page 1
Owner’s Guide For Models: PR5BZ PROSECRS RF Upgrade Kit IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may not apply.
Using Your Remote Control Arming the Security System To arm the system, exit the vehicle, close all doors, then press the button. The parking lights will flash 1 time, indicating the system is armed, has locked the doors (if equipped and connected) and activated the starter disable feature. The LED status indicator will blink steadily, once per second.
This helps to identify unauthorized transmitters from accessing your vehicle. If you believe an unauthorized transmitter has been programmed to your system, contact your installing dealer for assistance. PROSECRS PR5BZ Owners revA...
Valet Mode When valet mode is activated the status LED will light solid, and all security and remote start functions will be disabled. To enter or exit valet mode simply follow the steps outlined below: Turn the vehicle’s ignition ON. Push and hold the programming/valet button.
Page 6
If the Custom Code was accepted the LED will flash the first number (2), pause, then the second number (3). This will repeat 2 more times to confirm the Custom Code entry. If after 15sec the LED does not flash please repeat steps 1-7. PROSECRS PR5BZ Owners revA...
Using Your Remote Starter Remote Starting Your Vehicle To activate the remote start function, press and release the button 2 times within 2 seconds. The system will sound, the parking lights will flash 1 time and the system will check the vehicle to ensure it is safe to start. If all safety parameters are correct, the vehicle will start.
2 short/1 long tone and light flash pattern indicating Manual Transmission Ready Mode is active. Note: If the 2 short/1 long tone is not heard then Ready Mode has not been set. PROSECRS PR5BZ Owners revA...
Cancelling Remote Start Ready Mode - Manual Transmission Vehicles Only The system will exit remote start ready mode if any of the following occur: Open any door Open the hood or trunk (if connected) Press the brake Release the parking brake Turn the ignition ON Using the “Quick-stop”...
When set for 4 Hour - chirp 4 time and flash the parking lights 4 times. To exit the 2 / 4 hour start up timer mode: Turn the vehicle’s Ignition ON. Press the vehicle’s brake pedal while the engine is running. PROSECRS PR5BZ Owners revA...
Status LED, Light Flashes, and Siren/Horn Indications Status LED Flash Indications LED Flashes Function Disarmed Slow Flash Armed Fast Flash Passive Arming Countdown ON (Solid) Valet Mode 1 Flash / Disarmed Zone 1 Trigger, Shock Sensor 2 Flashes / Disarmed Zone 2 Trigger, Trunk / Hood 3 Flashes / Disarmed Zone 3 Trigger, Door...
1. Using a coin, disassemble the halves of the remote control. 2. Remove the old battery, observing the +/- symbols on the batteries and replace with a new battery. 3. Reassemble the halves of the remote control 4. Test operation of the remote control. PROSECRS PR5BZ Owners revA...
Page 13
LIMITED LIFETIME WARRANTY Applies to Pursuit Series Control Modules, Sirens, Sensors, and Relays. Voxx Electronics Corporation (the Company) warrants to the original purchaser of this product that should this product or any part thereof, (other than transmitters) under nor- mal use and conditions, be proven defective in material or workmanship during the life-...
2. This device must accept any interference received, including any interference that may cause undesired operation. Warning! Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. PATENTED: www.voxxintl.com/company/patents PROSECRS PR5BZ Owners revA...
Need help?
Do you have a question about the PR5BZ and is the answer not in the manual?
Questions and answers