Download Print this page

Elo Touch Solutions IDS 3201L User Manual page 20

Interactive digital signage android computer module
Hide thumbs Also See for IDS 3201L:

Advertisement

Notice to Users in Canada:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Notice to Users in the European Union:
Use only the provided power cords and interconnecting cabling provided with the equipment.
Substitution of provided cords and cabling may compromise electrical safety or CE Mark
Certification for emissions or immunity as required by the following standards:
This Information Technology Equipment (ITE) is required to have a CE Mark on the
Manufacturer's label which means that the equipment has been tested to the following
Directives and Standards: This equipment has been tested to the requirements for the CE Mark
as required by EMC Directive 2014/30/EU as indicated in European Standard EN 55022 Class
A and the Low Voltage Directive 2014/35/EU as indicated in European Standard EN 60950-1.
General Information to all Users:
This equipment generates, uses, and can radiate radio frequency energy. If not installed and
used according to this manual the equipment may cause interference with radio and television
communications. There is, however, no guarantee that interference will not occur in any
particular installation due to site-specific factors.
1) In order to meet emission and immunity requirements, the user must observe the following:
a) Use only the provided I/O cables to connect this digital device with any computer.
User Guide – ELO-KIT-ECMG2-AND
UM600069
Rev
B, Page 20 of 25

Advertisement

loading