Interactive digital signage for ids xxx3l (31 pages)
Summary of Contents for Elo Touch Solutions i-Series 2.0
Page 1
USER MANUAL Elo Touch Solutions Touch All in one computer i-series 2.0...
Page 2
Disclaimer The information in this document is subject to change without notice. Elo Touch Solutions, Inc. and its Affiliates (collectively “Elo”) makes no representations or warranties with respect to the contents herein, and specifically disclaims any implied warranties of merchantability or fitness for a particular purpose. Elo...
See Section 4 for more information on safety. This manual contains information that is important for the proper setup of the i-series 2.0 system. Before setting up and powering on your i-series 2.0 system, read through this manual, especially Unpacking and Operation, Safety, and Technical Support and Maintenance chapters.
Two (2) cable strain reliefs • Two (2) screws • The connectors are accessed by removing the cable security covers from the rear of the i-Series 2.0 system. User Manual – i-series 2.0 UM600106 Rev A, page 5 of 32...
Page 6
Elo i-series 2.0 Layout User Manual – i-series 2.0 UM600106 Rev A, page 6 of 32...
Page 7
For units with Power over Ethernet Support User Manual – i-series 2.0 UM600106 Rev A, page 7 of 32...
Page 8
2.0 EloView Engine The Eloview engine can be mounted to various Elo monitors using the VESA pattern or with optional monitor brackets. User Manual – i-series 2.0 UM600106 Rev. A, page 8 of 32...
Page 9
Power Press the power button to turn the Elo i-series 2.0 on. Press and hold power button when the system is on to bring up the Shut Down option popup. In the event that the system freezes and does not respond, press and hold the power button until the system turns off. If the system does not turn off via the power button, the system will need to be powered down by unplugging the power cord from the wall.
Page 10
Operating System System comes with Android 7.0.1 pre-loaded. Touch Technology The i-series 2.0 uses Projected Capacitance touch screens, 10 simultaneous touches can be reported at one time. Gesturing Images For multi-touch monitors, the following gestures are possible: Dual Touch Gestures and their Functions: Swipe –...
Page 11
DC-HSPA+ :UL (11 Mbps)/ DL (42 Mbps) • LTE FDD: UL (50 Mbps)/ DL (100 Mbps) @Bandwidth 20M (CAT3) • GPRS/EDGE: Multi-slot Class 12 Support country list • • Germany User Manual – i-series 2.0 UM600106 Rev. A, page 11 of 32...
Page 12
RS232 data output baud rate up to 115.2K BPS Payment Applications American Express ExpressPay Discover ZIP MasterCard PayPass/MCHIP Visa MSD/qVSDC Google wallet ISIS wallet User Manual – i-series 2.0 UM600106 Rev. A, page 12 of 32...
Page 13
Incorporates proximity detector to activate Bar Code Scanner. Outstanding scanning performance up to 270 scans per second. Below are the supported Bar Code types and settings. User Manual – i-series 2.0 UM600106 Rev. A, page 13 of 32...
Page 14
User Manual – i-series 2.0 UM600106 Rev. A, page 14 of 32...
Page 15
I-Series is equipped with an HDMI port that can support secondary monitors with HDMI (1920x1080@60) input. When using an Elo touch monitor as secondary display, enable touch by connecting the touch USB cable to the I-Series 2.0 type A USB port.
Page 16
Elo has a cable (PN # E086398) which extends this GPIO connection so that it is easy for users to connect their own peripherals. This cable can be found on the Elo website. Example Circuit User Manual – i-series 2.0 UM600106 Rev. A, page 16 of 32...
Page 17
G-Sensor All i-series 2.0 units are equipped with an g-sensor and will rotate the video based on the orientation of the device. The simple drawing below illustrates the orientation when the device is rotated. User Manual – i-series 2.0 UM600106 Rev. A, page 17 of 32...
Page 18
The USB 3.0 port will be disabled Global Positioning Satellite (GPS) The i-series 2.0 supports GPS functionality through software where the user can input the longitude and latitude coordinates in order to pin point the specific device. This allows the GPS to function even indoors.
Page 19
USB Control The i-series 2.0 provides control for each individual USB port. Any specific USB port can be turned off or on depending on the user. Intelligent Brightness Control To extend the life of the panel, Elo incorporates intelligent brightness control which disables the panels backlight during hours when the system is not being used.
Solutions to Common Problems Problem Suggested Troubleshooting The Elo I-series 2.0 does not respond when turning on Check that the power cable is properly connected to the wall. Power button LED will the system. be red when system is properly connected to the wall.
Page 21
Technical Assistance Technical Specifications Support visit www.elotouch.com/products visit www.elotouch.com/support for technical support for technical specifications for this device Refer to last page for worldwide technical support phone numbers. User Manual – i-series 2.0 UM600106 Rev. A, page 21 of 32...
Page 22
Elo I-series 2.0 Care and Handling The following tips will help maintain optimal performance of your Elo I-series 2.0: Disconnect the power cable before cleaning. To clean the unit (except for touch screen), use a soft cotton or microfiber cloth lightly dampened with a mild detergent.
Caution: Risk of explosion if battery is replaced by an incorrect type. Dispose of used battery according to the local laws and regulations. User Manual – i-series 2.0 UM600106 Rev. A, page 23 of 32...
CE Mark as required by EMC Directive 2014/30/ EU as indicated in European Standard EN 55032 Class A and the Low Voltage Directive 2014/35/EU as User Manual – i-series 2.0 UM600106 Rev. A, page 24 of 32...
Page 25
RF emission levels and may also present a lethal shock hazard to the user.) If you need additional help, consult your dealer, manufacturer, or an experienced radio or television technician. User Manual – i-series 2.0 UM600106 Rev. A, page 25 of 32...
Page 26
Radio Equipment Directive Elo hereby declares that the radio equipment type, i-series 2.0, is in compliance with Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following internet address: www.elotouch.com This device is designed and intended for indoor use only.
Page 27
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement." This equipment should be installed and operated to ensure a minimum of 20 cm spacing to any person at all times. User Manual – i-series 2.0 UM600106 Rev. A, page 27 of 32...
Page 28
The following certifications and marks have been issued or declared for this peripheral: FCC/IC • • UL/cUL/CB • Japan MIC • VCCI • China CCC • China SRRC • User Manual – i-series 2.0 UM600106 Rev. A, page 28 of 32...
Section 6: Warranty Information For warranty information, go to http://support.elotouch.com/warranty/ UM600106 Rev A, page 31 of 32 User Manual – i-series 2.0...
• Upcoming Events • Press Releases • Software Drivers To find out more about our extensive range of Elo touch solutions, go to www.elotouch.com, or call the office nearest you. Europe North America Asia-Pacific Latin America Tel +32 (0)16 70 45 00...
Need help?
Do you have a question about the i-Series 2.0 and is the answer not in the manual?
Questions and answers