Stanley FATMAX FME190 Original Instructions Manual page 7

Hide thumbs Also See for FATMAX FME190:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Health hazards caused by breathing dust developed when
u
sawing wood, especially oak, beech and MDF.
Injuries caused by prolonged use of a tool.
u
When using any tool for prolonged periods ensure you
take regular breaks.
Safety of others
This appliance is not intended for use by persons
u
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not
u
play with the appliance.
Vibration
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured
in accordance with a standard test method provided by
EN 62841 and may be used for comparing one tool with
another. The declared vibration emission value may also be
used in a preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level
may increase above the level stated. When assessing
vibration exposure to determine safety measures required by
2002/44/EC to protect persons regularly using power tools
in employment, an estimation of vibration exposure should
consider, the actual conditions of use and the way the tool
is used, including taking account of all parts of the operating
cycle such as the times when the tool is switched off and
when it is running idle in addition to the trigger time.
Labels on tool
The following pictograms along with the date code are shown
on the tool:
:
Warning! To reduce the risk of injury, the user
O
must read the instruction manual.
Wear safety glasses or goggles.
N
Wear ear protection.
6
Wear a dust mask.
Wear gloves when handling blades.
(Original instructions)
Electrical safety
#
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
Inspect tool cords periodically. If the supply cord is
u
damaged, it must be replaced by the manufacturer or an
authorised Stanley Fat Max Service Centre in order to
avoid a hazard.
Voltage drops
Inrush currents cause short-time voltage drops. Under
unfavourable power supply conditions, other equipment may
be affected. If the system impedance of the power supply is
lower than 0.34 Ω, disturbances are unlikely to occur.
Using an extension cable
Always use an approved extension cable suitable for the
u
power input of this tool (see technical data). Before use,
inspect the extension cable for signs of damage, wear and
ageing.
Replace the extension cable if damaged or defective.
u
When using a cable reel, always unwind the cable
completely. Use of an extension cable not suitable for the
power input of the tool or which is damaged or defective
may result in a risk of fire and electric shock.
Features
This tool includes some or all of the following features.
1. Air vents
2. Handle (left & right)
3. Socket
4. Shaft
5. Stirrer
6. Start-up Switch
7. Variable speed switch
8. Power cord with plug
9. Mounting spanner 22mm (x 2)
Assembly.
Unpacking.
Unpack all parts and lay them on a flat, stable surface.
u
Remove all packing materials and shipping devices, if
u
applicable.
Make sure the delivery contents are complete and free
u
of any damage. If you find that parts are missing or show
damage do not use the product but contact your dealer.
Using an incomplete or damaged product represents a
hazard to people and property.
Ensure that you have all the accessories and tools needed
u
for assembly and operation. This also includes suitable
personal protective equipment.
ENGLISH
7

Advertisement

Table of Contents
loading

Table of Contents