Connection; Terminal Positions; Connecting Procedure - Hitachi 42PD8800TA User Manual

CONNECTION

Terminal Positions

SD MEMORY
CARD
h
PUSH-EJECT
P
P
OK
PH35814

Connecting Procedure

This unit is ready for various kinds of connections. Make a connection in the following steps. Be sure to turn off the
Main Power fi rst when connecting external equipments.
1. Connect Power Cord to the rear panel.
2. Connect Aerial Lead.
3. Connect your external equipments to the unit if any.
4. Connect the Power Plug to the Wall Socket.
1. Connecting Power Cord to the Rear Panel
Connect Power Cord to the monitor.
*Make sure not to connect the Power Plug to the Wall Socket
until all connections are completed.
2. Connecting Aerial Lead.
There are two ways to connect Aerial Lead.
q When you do not have any other external equipment:
Connect the Aerial Lead directly into the Socket at rear panel.
w When you have one or more external devices to connect:
1. Use RF cable to connect between each equipment and
Antenna.
2. Connect the Aerial Lead to an equipment'In'Socket
marked
3. Connect the RF cable from the equipment 'Out' to the other equipment 'In.'
4. Then, connect from the equipment 'Out' to "ANT" on the plasma screen Socket on marked
Precautions when connecting the aerial
Please use a coaxial cable which is free from interference to connect the aerial. Avoid using a parallel fl at feeder
wire as interference may occur, causing reception to be unstable and stripe noise to appear on the screen.
Avoid using indoor aerial as this may be affected by interference. Please use CATV net or outdoor aerial.
For safety, install an external aerial conforming to AS1417.1 (applicable for Australia only)
If there are noise appearance in the picture of VHF-Low band channel, please use the double-shielded cable (not
provided) for RF LEADS to reduce the noise.
13
Downloaded From TV-Manual.com Manuals
PW3-12th-P1-P24.indd 13 PW3-12th-P1-P24.indd 13
42PD8800TA 55PD8800TA
w
INPUT(RGB)
AUDIO
ANT
a
ertyu
PC
ANALOG RGB
INPUT(HDMI)
INPUT INPUT INPUT INPUT AUDIO
OUTPUT
(AV1) (AV2) (AV3) (AV4)
WOW, SRS and symbol are trademarks of SRS Labs, Inc.
Y/VIDEO Y/VIDEO
Licensed by BBE Sound, Inc. under USP5510752 and 5736897.
BBE and BBE symbol are registered trademarks of BBE Sound, Inc.
s
i
S-VIDEO SUB HDMI2
P P WOOFER
B B
VIDEO
P R P R VIDEO VIDEO
HDMI1
SERVICE USE ONLY
AUDIO AUDIO AUDIO AUDIO AUDIO
L MONO L MONO L MONO L MONO L
o
C C C C
R R R R R
POWER SWIVEL
A C
q
Rear
q Power Cord Socket
g
w Aerial Socket
e AV1
r AV2
f
t AV3
y AV4
u Monitor Out and Sub Woofer
i Service use only
o Power Swivel Terminal
d
a PC Connection terminals
s HDMI1, 2 and mini stereo for Audio
Side
d AV5
f Headphone input
g Photo Input terminal
h SD Memory Card slot
[Example: Connecting Antenna
HITACHI
(see )
36
(D-sub 15 pin and mini stereo for
Audio)
STB VCR
IN IN
OUT OUT
through STB and VCR]
.
2005/11/09 9:48:20 2005/11/09 9:48:20