Basic Settings - Steinbach Poolrunner Battery Basic Owner's Manual

Charging process
1. Switch off the device before charging.
2. Connect the charger to the device.
3. Plug the charger into a socket.
The charge control indicator is lit red. The
rechargeable battery is charging.
4. When the charge control indicator is lit green,
disconnect the charger from the power supply
and the device.
The rechargeable battery is charged.

Basic settings

Adjusting the wheels
You can adapt the working radius by adjusting the wheels.
We recommend the following settings:
C-A: Setting for most pools (standard setting)
B-C: Setting for large pools
B-A: Setting for small pools
1. Press the retaining lug away from the half axle
and pull off the wheel.
2. Insert in the wheel with the catch so that it
snaps into place at the respective letter for the
selected setting.
The wheels are set.
Attaching the cleaning strips
Cleaning strips can improve the cleaning of your pool, depending on the conditions on site, such as
13
type and quantity of dirt or surface structure of the bottom. Only operate the device with the cleaning
strips attached if this leads to a better cleaning result.
1. Insert the cleaning strips
channels on the bottom of the bottom part
2. Make sure that the cleaning strips
properly engaged and have a tight fit.
The cleaning strips are attached.
Detaching the cleaning strips
1. Pull on the frames of the cleaning strips
The cleaning strips are detached.
into the suction
13
.
3
have
13
and take them out of the bottom part
13
1
2
3
3
13
.
3
23