Switching Off The Device - Steinbach Poolrunner Battery Basic Owner's Manual

Placing the device in the pool and starting cleaning
6
1. Hold the device by the handle
the air has escaped.
2. Press the ON/OFF switch
If the ON/OFF switch is pressed when the device is not in the water, it beeps and does not turn on.
The device switches on 15 seconds after it is lowered into the water.
3. Then let the device sink to the bottom of the pool.
Make sure that the device lands on the bottom of the pool on its underside and that cleaning can
start without obstruction towards the center of the pool.
The device is in the pool and starts cleaning with a time delay.
Cleaning stops automatically if the rechargeable battery dies. Press the ON/OFF switch
to stop cleaning early and to switch the device off.
11

Switching off the device

Proceed as follows to switch off the device:
1. Lift the device out of the pool and switch it off.
2. Clean the filter unit and the device.
Lifting the device out of the pool
1. Slowly pull the device by the handle
included).
2. Grab the device by the handle
This way you ensure that the dirt collected in the filter does not wash out again.
3. Hold the device upside down above the water surface.
After 10 to 15 seconds, most of the water that has collected in the housing has drained back into
the pool.
4. Press the ON/OFF switch
The device is switched off.
5. Set down the device next to the pool.
The device is lifted out of the pool.
Clean the device after each use to ensure continued trouble-free operation.
and lower it slowly into the water (tipped slightly forward) until all
6
on the bottom until it snaps into place.
11
to the surface using the hook
6
and turn it upside down while slowly lifting it out of the water.
6
on the bottom until it snaps into place.
11
7
11
and a telescopic rod (not
4
25