Operation; Cleaning The Pool - Steinbach Poolrunner Battery Basic Owner's Manual

Operation

Hair or clothing can be sucked in or trapped by the cleaning element, hold persons under
water and, in extreme cases, prevent them from resurfacing.
- Never operate the device while there are persons in the pool.
- Prevent any access to the pool as long as the device is in operation.
Check the following before each use:
- Is there visible damage on the device?
- Is there visible damage on the control elements?
- Do all individual parts function?
- Are the accessories in perfect condition?
- Are all cables in perfect condition?
Do not start up a damaged device or damaged accessories. Have them checked by the manufacturer or
its customer service or a qualified service technician.

Cleaning the pool

Observe the following before cleaning your pool:
- Remove any cover or foil from the pool.
- Remove obstacles (such as a ladder) from the pool.
- Switch off the filter system at least one hour before the start of cleaning so that particles in the
water can settle on the floor.
Proceed as follows to clean your pool:
1. Insert the filter unit.
2. Place the device in the pool and switch it on.
Inserting the filter unit
4
2
9
3
1. Make sure that the dirt flaps
2. Insert the filter unit
upwards.
3. Place the top part
guide lugs on the marked locking points.
4. Close all clips
10
The filter unit is inserted.
24
Do not operate while swimming! Mortal danger!
are closed before inserting the filter unit.
9
into the bottom part
2
in the correct position on the bottom part
1
.
WARNING!
5
1
3
10
in the correct position with the guide lugs pointing
3
3
. In doing so, pay attention to the