Operation - Royal Sovereign ARP-7010 Owner's Manual

OPERATION

Before Use
• Check to make sure rubber drain plug is securely plugged into the drain port on the back of the unit to prevent water leaks
• Check to make sure that air conditioner has been properly vented out the window ( See Installation pg 6.)
• Check to make sure air conditioner is on a flat surface
• Push down on the back of the louver located on the top of the unit. The louver will snap into open position. To close while unit is not in use, simply press back down.
Do not run the air conditioner with the louver closed. This may damage the air conditioner.
• Conduct a Power Plug Check:
1. Press the RESET button on the power cord.
2. Plug cord into an electrical outlet.
3. Press the TEST button on the power cord. The RESET button should pop up.
4. Press the RESET button for use.
5. Do not use the air conditioner if the test fails.
Note: If you turn the air conditioner off and immediately restart it, allow 3 minutes for the compressor to restart cooling. In the event of a power failure, wait 3 minutes
before restarting unit.
Control Panel
Temperature set
control
ON / Off button
Remote control receiver
ARP-7010, ARP-7013, ARP-7013H
7
Mode control
Fan speed control
Timer set control
Water Full light
Display