Installing A New Paper Roll - Royal 600sc Instruction Manual

Installing a New Paper Roll

As you use the cash register, you will need to replace the paper roll.Your
cash register has a thermal printer that prints receipts for the customer or a
journal tape. Use 2¼ inch (57.5 mm) wide standard thermal register paper.
To install the paper roll
1 Insert the PRG key and turn it to either REG1 or REG2.
2 Unlock and open the Journal Compartment Cover. Grip the left side of
3 Remove the Journal
4 Grab the small
5 Lay the end of the paper across the
6 Do one of the following:
Alpha 600sc User's Guide
• If you need a customer receipt, turn the Mode key to the REG1
position.
• If you do not need a customer receipt, turn the mode key to the REG2
position.
the cover and gently pull upward. Remove the Journal Compartment
Cover and set aside.
Takeup spindle.
Place the paper roll
in the little round
area at the bottom of
the compartment.
Make sure the paper
feeds out from the
bottom of the roll,
towards the front of
the cash register.
handle on the right of the print
roller. Push the little handle towards
the back of the cash register and
raise the roller bar up.
printer as shown. Move the print
roller down onto the paper and
snap into place. Make sure both
sides are snapped down.
• Press the Feed key until the paper catches and moves through the
printer.
Installing a New Paper Roll
Handle
85