Royal 600sc Instruction Manual page 10

Chapter 2: Getting Started
Make sure that you plug the cash register into the electrical outlet before
you put in the batteries.
To get the cash register ready to use
1 Remove the cash register and the parts from the box. Store the box and
2 Remove the tape holding the parts of the cash register in place. For
3 Put the register on a hard, level surface, away from rain and spilled
4 Plug the cash register into a standard three-hole electrical wall outlet.
5 Install the memory backup batteries.
4
Caution
If you put the batteries in first, they can damage the cash register.
Do not use this cash register outdoors in the rain or near any source of
liquid.
packing material in a safe, dry place. If you need to move the register in
the future, you can put it back in the box.
example, there may be tape on the Journal Compartment Cover. Make
sure you remove the tape on the black Journal Tape spindle inside the
printer compartment of the cash register.
drinks. A hard level surface makes it easier for the cash drawer to go in
and out smoothly.
Do not put the register on a porous surface. Depending on the surface or
any cleaning solution used on the surface, the rubber feet may leave
marks on the surface. Do not place the register on any valuable surface,
such as antique or fine wood tables, desks, and so on.
(115-120 volt, 60 hertz). Make sure the electrical cord is not going to get
tripped over or accidentally pulled from the electrical outlet.
Put the cash register on an electrical circuit with no other electrical
device or appliance. Other appliances can overload the circuit or cause
electrical interference with the cash register. It is best that you use a
circuit without other appliances already on it.
• Open the Journal Compartment cover. Remove
the cover and put it aside.
• Move the paper roller bar up and out of the way.
Grab the small handle on the right of the print
roller bar. Push the little handle towards the
back of the cash register and raise the paper
roller bar up. You see a slope down to the paper
compartment. The battery cover is located under the print roller bar,
on the slope.
• Remove the battery cover. Press the edge at the top of the cover and
push to the back. The cover pops off.
Alpha 600sc User's Guide