Installing The Paper Roll - Royal 600sc Instruction Manual

6 Now you are ready to put the paper in the cash register and set the time

Installing the Paper Roll

Your cash register has a thermal printer that prints receipts for the
customer or a journal tape. Use 2¼ inch (57.5 mm) wide standard thermal
register paper.
To install the paper roll
1 Insert the PRG key and turn it to either REG1 or REG2.
2 Unlock and open the Journal Compartment Cover. Grip the left side of
3 Remove the Journal
Alpha 600sc User's Guide
• Put the batteries in the slots. Make
sure that the positive and negative
ends are in the right place. The
batteries have a little plus (positive)
and minus (negative) sign on each end
to help you.
• Replace the battery cover. Slide the
bottom tabs into the long slit in the
bottom position and it snap the cover
into place. Do not put the tabs in the 2
holes in the bottom of the
compartment. The cover will not close and you will break the tabs.
and the date. See the next section for more information.
• If you need a customer receipt, turn the Mode key to the REG1
position.
• If you do not need a customer receipt, turn the mode key to the REG2
position.
the cover and gently pull upward. Remove the Journal Compartment
Cover and set aside.
Takeup spindle. Place
the paper roll in the
little round area at the
bottom of the
compartment. Make
sure the paper feeds
out from the bottom
of the roll, towards
the front of the cash
register.
Installing the Paper Roll
5