E+E Elektronik EE895 User Manual page 19

Measuring status: indicates when new single shot measurement is possible.
Register
Function
1)
address
code
[HEX]
0x03 0x1F9
1) Register address starts from 0
Tab. 15 Single shot measurement possible
Measuring trigger: command for the single shot measurement. For accurate measurement results, there are
recommended six single shot measurements under stable temperature conditions.
Register
Function
1)
address
code
[HEX]
0x06 0x1FA
1) Register address starts from 0
Tab. 16 Command single shot measurement
EE895 detailed status
Register
Function
1)
address
code
[HEX]
0x03 0x258
1) Register address starts from 0
Tab. 17 Status details
Note
[Bit 0]: Data ready. The data are available for read out.
0 = busy, 1 = ready
[Bit 1]: Trigger ready. The EE895 is ready for new measurement cycle.
The minimum time interval between two triggers is 10 s.
0 = trigger not possible
1 = ready for new trigger
[Bit 2..15]
reserved (do not use)
Note
[Bit 0]: Measurement Trigger
0 = don't care
1 = Start new measurement cycle
[Bit 1..15]
reserved (must be written as 0)
Note
[Bit 0]: CO measurement too high
2
[Bit 1]: CO measurement too low
2
[Bit 2]: T measurement too high
[Bit 3]: T measurement too low
[Bit 6]: p measurement too high
[Bit 7]: p measurement too low
[Bit 8...15]: reserved (do not use)
Miniature Sensor Module for CO , Temperature and Barometric Pressure | 19
2
User Manual EE895