Table of Contents
Advertisement
www.ti.com
Next, with the output disabled, connect the input current source to the EVM via T1 and T2, as shown in
Figure
10.
NOTE: The lug connectors can accommodate wire sizes up to #6-AWG.
Also be sure to connect the low-side terminal of the input current source to EVM ground (GND) using one
of the test points. This step is important to obtain accurate V
Lastly, connect the SM-USB-DIG to the computer, using the included USB extender cable if necessary. At
this point the SM-USB-DIG powers on, but the EVM does not.
The power supply to the EVM must be enabled from the GUI.
Figure 10. SM-USB-DIG Powers on When Connected to a Computer
SBOU180 – November 2016
Submit Documentation Feedback
Copyright © 2016, Texas Instruments Incorporated
INA260EVM-PDK Setup
measurements.
BUS
INA260EVM-PDK and Software Tutorial
17
Advertisement
Table of Contents
