Switching On And Off/Setting Speed Range; Notes On Working With Materials/Tools/Speed Range; Cleaning, Care And Storage - Parkside 303129 Translation Of The Original Instructions

Switching on and off/setting speed
range
CAUTION!
■ The rotating direction of the grinding spindle
can be read off the arrow engraved on the
front of the appliance (anticlockwise symbol).
Switching on/setting the speed range:
♦ Set the ON/OFF switch
♦ Set the steplessly adjustable speed control
a position between "1" and "6".
Switching off:
♦ Move the ON/OFF switch
Notes on working with materials/
tools/speed range
■ Determine the rotational speed range for work-
ing on zinc, zinc alloys, aluminium and copper
by trying it out on test pieces.
PGS 500 A1
to the "I" position.
to
to the position "O".

Cleaning, care and storage

WARNING! RISK OF INJURY!
■ Switch off the appliance and pull out the
power plug before starting any work on
the appliance.
The appliance is maintenance-free.
■ Remove all dirt from the appliance. Use a dry
cloth to do this.
WARNING!
■ If the power cord requires replacement, this
should be carried out by the manufacturer or
an approved representative to avoid safety
hazards.
■ Store the appliance and all the individual
pieces carefully in the provided plastic case to
ensure you do not lose any part.
NOTE
► Replacement parts not listed (such as carbon
brushes, switches) can be ordered via our
service hotline.
WARNING!
■ Always ensure that the power plug or
the mains cable is replaced only by the
manufacturer of the appliance or its
customer service. This will ensure that the
safety of the appliance is maintained.
GB │ IE │ NI │
9 ■