Assembly And Setup - Schiller BOB-CAT 942509J Parts Manual

PREDATOR-PRO
LP SERIES
TOOLS REQUIRED FOR ASSEMBLY
- Wrecking bar
- Claw hammer
- Ratchets: 3/8",e
- Sockets: 9/16", 3/4"
- Wrenches: 3/8", 9/16", 3/4"
- Straight edge
- Tire pressure gauge
- Blocks (for deck leveling)
NOTE: All references below to the "right" or "left" are with respect to an operator at the controls.
1. UNCRATE UNIT
Discard packing materials. Remove and discard shipping brackets. Tighten caster wheel axle bolts
against caster axle spanner bushings.
2. 72" in. deck models: Tires need to be installed using eight 64187-03 wheel nuts included in hardware
bag. Torque nut to 75 - 110 ft./lbs.
3. Set rear tire pressures to 12 lbs/in
tires
4. DECK LEVELING
a) Park the machine on a smooth, level surface.
Raise the deck to the transport position.
b) SIDE DISCHARGE: Lower the deck onto a pair
of equal height blocks A under the rear corners
of the deck. Place another pair of adjustable
blocks A under the front of the deck so that the
deck top is level.
REAR DISCHARGE: Lower the deck onto a pair
of equal height blocks A under the rear corners
of the deck. Place another pair of adjustable
blocks A under the front of the deck so that the
deck is level.
NOTE: The front and rear of the deck are at different
heights.
c) Measure the height of the blade cutting edge
above the ground. Remove pin C and set the
height of cut lever D to that height.
d) Loosen nuts I at all four corners of the deck.
NOTE: This will relieve tension on chains H.
). Tires are overinflated for shipping. Front tires are no flat
2 2
(0.8 kg/cm
e) Loosen the jam nuts E on the height of cut clips
F and adjusting screws G. Turn the adjusting
screws G until the play is taken out of the chains
H at all four corners. Tighten the jam nuts E
against the clips F and at the adjusting screws G.
Retighten nuts I at this time.

ASSEMBLY AND SETUP

5