Table of Contents
Advertisement
VIPA HMI
User memory
USB storage media
Slot for CF
Slot for SD/MMC
Security flap for memory
cards
2.3.4 RFID reader
Overview
HB160 | TP | 62M-JIDR | en | 20-20
As internal permanent storage medium every Touch Panel has a flash disc with a size of
512Mbyte (about 380Mbyte user data). After the start of Windows
listed as Flashdiskunder My Device.
The connection of USB sticks and USB drives by use of the "Host"-USB-A interface is
supported by the Touch Panel. After connection the storage media is listed as Hard Disk
under My Device.
Here you can plug a CompactFlash
during runtime and is immediately listed as Storage Card at My Device.
Ò
Every CompactFlash
storage module has a pulling edge. Hold the CompactFlash in the
way that the pulling edge points to the left side. Push the storage module without much
power into the slot until the impact. To remove the card touch it at the pulling edge and
pull.
On this slot you can plug storage modules of the type SD or MMC. The card may be
plugged and removed during runtime and is immediately listed as SDMMC Card at My
Device.
Please take care to plug the according card as shown on the back of the Touch Panel.
On the left side of the Touch Panel are the card slots for memory cards. The cards are
visibly covered by a security flap and are thus secured from slipping out.
Please take care to pull the security flap back before plugging or pulling a memory card
like shown in the illustration and put it back again afterwards. When plugging, the security
flap additionally snaps into position above the plugged memory card.
n
RFID (Radio Frequency Identification) is a technology that use radio waves to auto-
matically identify objects and people. An RFID system consists of an RFID trans-
ponder with an active or passive Tag and an RFID reader.
n
The Touch Panel 62M-JIDR-... has an integrated a RFID reader at the front side on
the left. The position of the RFID readers is indicated by the RFID symbol. The RFID
module reads the UID of the transponder card without contact up to a distance of 4
cm. This enables the identification of the user on the Touch Panel.
'Deployment RFID reader' page 24
The RFID transponder card SCC-ICSLI from iDTRONIC GmbH is a VIPA
certified component.
Ò
type II. The card may be plugged and removed
Hardware description
Structure > RFID reader
Ò
CE this memory is
Ä Chap. 3.3
13
Advertisement
Table of Contents
