Related Manuals for Omega AOK 20SS Ex
Summary of Contents for Omega AOK 20SS Ex
- Page 1 Installation and operating manual AOK 20SS Ex Document : 3403490 Rev. : 001 Date : 25.9.2020...
-
Page 2: Table Of Contents
Product description ......................6 4.1. Components ........................ 6 4.2. Operation ........................7 Technical data ........................8 5.1. Technical data AOK 20SS Ex ..................8 5.2. Dimensional drawing ....................8 5.3. Materials ........................8 5.4. Pressure equipment directive PED 2014/68/EU ............8 Installation .......................... -
Page 3: Introduction
AOK 20SS Ex - Installation and operating manual 1. Introduction Please read the following instructions carefully before installing the product. Trouble free and safe operating of the product can only be guaranteed if recommendations and conditions stated in this manual are respected. -
Page 4: Safety Instructions
2. Safety instructions 2.1. Product safety Product should only be used in a technically perfect condition and in the intended, safety and danger-aware method, taking into account the operating instructions. 2.1.1. Safety instructions regarding transport and storage The product must be transported and stored in its protective packaging until it is installed. -
Page 5: Appropriate Use
3. Appropriate use 3.1. Intended usage AOK 20SS Ex is intended to drain condensate from compressed system. To collect the condensate as effectively as possible, the drain should be installed at a low point of the pipe section. -
Page 6: Product Description
4. Product description 4.1. Components Bill of materials Cheese head screw M8x30 Flat washer Pan head screw M5x8 External tooth washer Housing lid O-ring sealing 71 x 2 Float holder Rivet Nozzle Wire Flat seal Housing Test lever button O-ring sealing 2,5 x 0,65 External circlip Lever holder Pan head screw M4x6... -
Page 7: Operation
AOK 20SS Ex - Installation and operating manual 4.2. Operation Test ON/OFF Drain must be installed bellow pressure vessel, filter element, dryer, cyclone separator or similar pressure system element. Through connection on the top condensate accumulates in the drain reservoir. Increasing water level rises the floating buoyancy. When the condensate level is high enough the floater unblocks the discharge orifice via levers and the condensate is purged out through output connection. -
Page 8: Technical Data
5. Technical data 5.1. Technical data AOK 20SS Ex Technical data Operating temperature 1,5 - 120 °C 35 – 248 °F Operating pressure range 0 - 20 bar(g) 0 - 290 psi Minimum recommended operating 1,5bar(g) 21,8 psi pressure Operating media... -
Page 9: Installation
AOK 20SS Ex - Installation and operating manual 6. Installation Before installing the product, check that thy system is not under pressure. Wear necessary personal protective equipment and folow the safety rules when working with pressure equipment. The product should be unpacked at the installation location and inspected for damage prior to installation. -
Page 10: Maintenance
7. Maintenance The automatic operation of the product requires maintenance to ensure that it continuous to operate perfectly. Before maintenance depressurize the product and keep to the safety rules when working with pressure equipment. Weekly: Rotate the "Test" button and manually drain the accumulated condensate until air begins to blow from the drain. -
Page 11: Warranty Exclusion
AOK 20SS Ex - Installation and operating manual 9. Warranty exclusion The guarantee shall be void if: The installation and operating manual was not followed with respect to installation, initial commissioning and maintenance. The unit was not operated properly and appropriately. - Page 12 OMEGA AIR d.o.o. Ljubljana Cesta Dolomitskega odreda 10 SI-1000 Ljubljana, Slovenia Tel.: +386 (0)1 200 68 00 Fax.: +386 (0)1 200 68 50 E-mail: info@omega-air.si www.omega-air.si...