Table of Contents
Advertisement
FRONT PANEL FEATURES OVERVIEW
6. DC OVERLOAD Indicator Light
Indicates System Power Overload Status
Color / State
Green
Yellow Flashing Slow
Red Flashing Slow
Red Flashing Fast
• When the total DC load exceeds 90% of total capacity (135W), the DC OVERLOAD indicator will turn yellow and switching of additional DC
outputs will be inhibited.
• When the total DC load reaches 100% of total capacity (150W), the DC OVERLOAD indicator will turn red and switching of additional DC
outputs will remain inhibited.
• Should the total DC load exceed 110% of total capacity (165W), the DC OVERLOAD indicator will ash red and DC12-IP will automatically
switch DC outputs off. In this state, the DC outputs will switch off from lowest priority (output 12) to highest priority (output 1) until the total DC
load is 150W or less.
• If an output has been turned on in the last 5 seconds, it will be turned off rst before shutting off subsequent lower priority outputs.
7. BlueBOLT Indicator Light
Indicates the status of the network connection
Color / State
Flashing Green
Flashing Blue
Solid Blue
Status
Indicates the system wattage is less than 135 Watts or whether any of the following states have activated and the wattage
has returned to less than 127 Watts.
Indicates the system wattage is equal to or has exceeded 135 Watts. At this instance, turning on outputs is inhibited.
(Inhibit Mode)
Indicates the system wattage is equal to or has exceeded 150 Watts. At this instance, turning on outputs is also inhibited.
(Warning Mode)
Indicates the system wattage is equal to or has exceeded 165 Watts. If an output has been turned on in the last 5
seconds, it will be shutdown rst. From that point on, starting at output 12, each output will be turned off until power has
returned to less than 165 Watts. (Priority Shutdown Mode)
Status
No network connection
Attempting to contact BlueBOLT or BlueBOLT connection failed.
BlueBOLT communication established.
7
Advertisement
Table of Contents
