Table of Contents
Advertisement
DC12-IP User Guide
POWER CYCLE AND OUTPUT SEQUENCING
The DC outputs of DC12-IP are con gured to turn ON and OFF in a programmed sequence where each output has a set of programmed delay times. The
delay times are pre-programmed, but they may be changed on the BlueBOLT or local web site interface. The default con guration is:
Output
1
2
3
4
5
6
7
8
9
10
11
12
Power Cycle Delay
When a Power Cycle is initiated, the DC output will immediately turn off and then back on after the Power Cycle Delay time
Turn On Delay
When a Turn On Sequence is initiated, the DC output will turn on after the Turn On Delay time.
Turn Off Delay
When a Turn Off Sequence is initiated, the DC output will turn off after the Turn Off Delay time.
Sequence Enable
When enabled, the DC output will switch ON or OFF during a sequence. It is initiated by pressing the front panel Sequence On or Sequence Off button
within BlueBOLT interface or local web interface. When not enabled, the DC output will not participate in turn on or turn off sequences.
SPECIFICATIONS
Input Voltage
Input Frequency
Maximum Input Power Rating
Maximum DC Output Current, Total
Maximum DC Output Current, Per Bank
Total DC Output Power
Maximum Operating Temperature (Tma)
Regulatory
Power Cycle Delay (seconds)
Turn On Delay (seconds)
10
1
10
1
10
5
10
10
10
15
10
20
10
25
10
30
10
35
10
40
10
45
10
50
Turn Off Delay (seconds)
1
50
45
40
35
30
25
20
15
10
5
1
90 – 264Vac
47 – 63Hz
180 W @ 120Vac (DC output fully loaded)
12.5A @ 12VDC
26.0A @ 5VDC
5.0A @ 12VDC
2.2A @ 5VDC
150W
40°C (104°F)
United States:
FCC Part 15B, UL 62368-1
Canada:
ICES-003 B, CAN/CSA C22.2 No. 62368-1
UK:
BS EN 55032, EN 55035, EN 62368
EU:
EN55032, EN55035, EN62368
Australia / New Zealand:
SAA, AS/NZS CISPR32
14
Sequence Enable
Not Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Advertisement
Table of Contents
