Advertisement
3.13 S
S
ET
UPERVISOR
The "SUPERVISOR/USER PASSWORD" utility sets the password. The SBC is shipped
with the password disabled. If you want to change the password, you must first enter the
current password, then at the prompt -- enter your new password. The password is case
sensitive, and can be up to 8 alphanumeric characters. Press <Enter> after you have
finished typing in the password. At the next prompt, confirm the new password by
re-typing it and pressing <Enter> again. When you are done, the screen automatically
reverts to the main screen. Remember that when you use this feature, the "Security
Option" line in BIOS FEATURES SETUP will determine when entering the password will
be required.
To disable the password, press the <Enter> key instead of entering a new password
when the "Enter Password" in the dialog box appears. A message will appear confirming
that the password is disabled.
If you have set both supervisor and user password, only the supervisor password allows
you to enter the BIOS SETUP PROGRAM.
Note : If you forget your password, the only way to solve this problem is to discharge the
CMOS memory.
3.14 S
& E
AVE
Select this option and press the <Enter> key to save the new setting information in the
CMOS memory and continue with the booting process.
3.15 E
W
XIT
ITHOUT
Select this option and press the <Enter > key to exit the Setup Utility without recording any
new values or changing old ones.
/ U
SER
S
XIT
ETUP
S
AVING
P
ASSWORD
~ 45 ~
AWARD BIOS SETUP
Advertisement
