Advertisement
JUMPER SETTING AND CONNECTORS
2.3 J
S
O
UMPER
ETTING
VERVIEW
In order to select the operation modes of your system, configure and set the jumpers on your
single board computer to match the need of your application. To set a jumper, a black plastic
cap containing metal contacts is placed over the jumper pins as designated by the required
configuration as listed in this section. A jumper is said to be " on " or " 1-2 " when the black
cap has been placed on two of its pins, as show in the figure below:
A pair of needle-nose pliers is recommended when working with jumpers. If you have any
doubts about the best hardware configuration for your application, contact your local sales
representative before you make any changes. In general, you simply need a standard cable
to make most connections.
~ 6 ~
Advertisement
