Page 1
fixing devices from those supplied. Phillips & Flathead screwdrivers and hammer required. *We recommend using a Flathead screwdriver to tighten all locking nuts 100% before first use. mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...
Page 2
Insert 8x bolts (C) into panel [1] and tighten with a screwdriver. Attach 1x slide rail (F) and 1x slide rail (G) to panels [3] and [5] as shown and secure with 6x screws (E). Tighten with a screwdriver. mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...
Page 3
Attach panels [3], [4], [5] and [6] to panel [1] with 8x dowels (A) and secure as shown and secure with 6x screws (E). Tighten with a screwdriver. with 8x locking nuts (D). Tighten with a screwdriver. mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...
Page 4
Attach 2x bracket (M) to panel [2] and secure with 4x screws (E). to form the back of the unit. Tighten with a screwdriver. Place 2x cover (N) over the bracket (M) as shown. mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...
Page 5
Attach panel [2] to the unit with 8x dowels (A) and secure with 8x screws (B). 8x spring washer (Q). Tighten with an Allen key (T). Attach 4x felt pads Tighten with a screwdriver. (L) to legs [8] as shown. mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...
Page 6
Insert 4x bolts (C) into panel [9]. Attach 1x seal (O) to panel [8] and secure with 1x screw (E). Tighten with a screwdriver. with 1x screw (E). Tighten with a screwdriver. mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...
Page 7
Ensure the drawers slide easily along the rails. If the door is not catching or sitting flush, twist the end of the cover (N) until it catches on the seal (O). mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...
Page 8
1x washers (Z), 1x wall anchor (X) and 1x screws (Y). Ensure unit 1x screws (W). Tighten with a screwdriver. is balanced and steady before use. You’re done, enjoy! mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...