SELT ITALIA Installation Manual
Balcony awning
Hide thumbs
Also See for ITALIA:
- Installation manual (29 pages) ,
- Original instructions manual (30 pages)
Related Manuals for SELT ITALIA
Summary of Contents for SELT ITALIA
- Page 1 11.10 DT-E TECHNICAL AND OPERATIONAL DOCUMENTATION INSTALLATION MANUAL, OPERATING MANUAL AND INSTRUCTIONS FOR SAFE USE (Translated from the original manual) Awnings 11.10 Balcony awning ITALIA...
- Page 2 THIS TECHNICAL AND OPERATIONAL DOCUMENTATION: Is valid from: 28 March 2022 Is applicable to the above listed product versions. DT-E 11.10 SUN PROTECTION SYSTEM – BALCONY AWNING ITALIA Edition 7/ March 2022 / EN page 2 / 28...
-
Page 3: Table Of Contents
MARKING AND LABELLING OF THE PRODUCT WITH CE MARK ..................27 10.1 PRODUCT COMPLIANCE WITH THE CE STANDARD ..................27 10.2 INFORMATION ACCOMPANYING THE CE MARKING ..................27 DT-E 11.10 SUN PROTECTION SYSTEM – BALCONY AWNING ITALIA Edition 7/ March 2022 / EN page 3 / 28... -
Page 4: Introduction
Threat to human life or health due to electric shock. Marking of electronic or electric equipment, which should be collected in the ENVIRONMENT designated points. DT-E 11.10 SUN PROTECTION SYSTEM – BALCONY AWNING ITALIA Edition 7/ March 2022 / EN page 4 / 28... -
Page 5: Terms And Definitions
SELT SP. Z O.O. with a head office in Opole shall hold the copyrights to this documentation. The documentation cannot be used without permission, either partially or as a whole, for any concurrent business activity nor can it be made available to third parties. -
Page 6: Product Technical Information
The optional use of weather automation additionally protects the product against changing weather conditions. PRODUCT SPECIFICATION Products manufactured by SELT Sp. z o. o. have appropriate technical and operational parameters. They have the following features: They provide excellent sun protection for surfaces such as terraces and balconies. -
Page 7: Italia Awning Construction
Awning fabrics manufactured on the basis of high-quality materials, covered with an impregnation that constitutes a protective barrier and increases resistance to dirt. ITALIA AWNING CONSTRUCTION DT-E 11.10 SUN PROTECTION SYSTEM – BALCONY AWNING ITALIA Edition 7/ March 2022 / EN page 7 / 28... -
Page 8: Transport And Storage Of The Product
COMPLETENESS AND QUALITY CONDITION OF DELIVERY SELT Sp. z o. o. makes every effort to ensure that the goods comply with the order. However, checking the completeness of the product is the responsibility of the Buyer and should take place at the time of its receipt. -
Page 9: Product Installation
This chapter contains general requirements concerning the product installation. Correct assembly is a necessary condition for smooth operation of the product. SELT Sp. o.o. recommends using only professional assembly crews, which guarantee the Purchaser that the conducted installation will be correct. -
Page 10: Preparation For Installation
In case of remotely operated awning, bracket for remote control should be installed in place not available for children, Electrical installation, first programing of motor and specialized service can be conducted solely by specialized service companies. DT-E 11.10 SUN PROTECTION SYSTEM – BALCONY AWNING ITALIA Edition 7/ March 2022 / EN page 10 / 28... -
Page 11: Installation Tools
4.5.1 ITALIA AWNING INSTALLATION – WALL BRACKET S SELT recommends the use of Fischer fixing products - selected depending on the type of substrate. Suggested recommendations for selected substrates: for non-cracked concrete class C20/25 and not higher than C50/60: M10x110 A4 anchors set on injection mortar (Fischer FIS A M10x110 A4 anchors on FIS V resin or an equivalent ... - Page 12 6) Set up the awning with plug and square pin on the bracket 7) Insert the slide bearing to the round pin on the from the drive side roller tube ending. DT-E 11.10 SUN PROTECTION SYSTEM – BALCONY AWNING ITALIA Edition 7/ March 2022 / EN page 12 / 28...
- Page 13 11) Take off the awning and drill holes in marked places. 12) Fix installation anchors. 13) Screw on the bracket. DT-E 11.10 SUN PROTECTION SYSTEM – BALCONY AWNING ITALIA Edition 7/ March 2022 / EN page 13 / 28...
- Page 14 Block the bearing with Allen screw. 16) Open the awning slightly. 17) Slide the arms endings to the front bars channel and secure them with screws. DT-E 11.10 SUN PROTECTION SYSTEM – BALCONY AWNING ITALIA Edition 7/ March 2022 / EN page 14 / 28...
- Page 15 18) Start the arms installation with marking the installation spots for arm brackets. 19) Unscrew the arm from the front bar and drill holes in marked places. DT-E 11.10 SUN PROTECTION SYSTEM – BALCONY AWNING ITALIA Edition 7/ March 2022 / EN...
-
Page 16: Italia Awning Installation - Niche Brackets
25) Install front bar caps using pad). screws. 4.5.2 ITALIA AWNING INSTALLATION – ARM BRACKETS INST ALLATION IN A NICHE (NICHE BRACKET) The arm brackets can be installed in a niche with niche brackets. The niche brackets should be installed in the same order and manner as wall brackets.. -
Page 17: Electric Drive
Incorrect connection of the motor can lead to product damage or create a hazardous situation. DT-E 11.10 SUN PROTECTION SYSTEM – BALCONY AWNING ITALIA Edition 7/ March 2022 / EN page 17 / 28... -
Page 18: Remote Operation
Do not allow the fabric to be rolled in the opposite direction (from the bottom of roller tube), since it may cause its ripping off the roller tube, fabric damage or incorrect awning functioning. DT-E 11.10 SUN PROTECTION SYSTEM – BALCONY AWNING ITALIA Edition 7/ March 2022 / EN... -
Page 19: System Operation And Product Safety
- otherwise it will lead to permanent damage It is recommended that the change of equipment configuration be consulted with SELT. SAFETY REQUIREMENTS RELATED TO SPECIAL CONDITIONS AND PLACES OF PRODUCT USE Specific safety requirements relate to children up to 42 months. Essential requirements for use are applicable in all locations, to which children have access or where they could be present. -
Page 20: Operational Safety
Automatically controlled products may start up on their own. Make sure that no dangerous situation arises. SELT Sp. z o. o. is not responsible for damage caused by improper use. Operating the system out of sight can cause serious injury as well as damage to the system... -
Page 21: Control Of Safe Use Of The Product
- switching on and off by pressing the control buttons, maintenance of the product is described in the further part of the documentation. TECHNICAL INSPECTIONS, MAINTENANCE AND REPAIR DT-E 11.10 SUN PROTECTION SYSTEM – BALCONY AWNING ITALIA Edition 7/ March 2022 / EN page 21 / 28... -
Page 22: Use Of Awning Fabrics
Possible adjustment and improvement of fastening of the mentioned components. Products manufactured by SELT Sp. z o. o. do not require any special maintenance. Using the product in accordance with the manufacturer's instructions ensures long-term and trouble-free operation for the system user. Ongoing maintenance work should be carried out on a fully developed system. -
Page 23: General Warranty Terms
GENERAL WARRANTY TERMS General warranty terms are available on www.selt.com If the SELT Sp. z o.o. website is inaccessible then warranty terms and conditions can be obtained from the sales representative of SELT Sp. z o.o. WARRANTY EXCLUSIONS The warranty will not cover: ... - Page 24 For awning fabrics the phenomena described in the section “Use of awning fabrics.” Selection of electric motors: DT-E 11.10 SUN PROTECTION SYSTEM – BALCONY AWNING ITALIA Edition 7/ March 2022 / EN page 24 / 28...
- Page 25 DT-E 11.10 SUN PROTECTION SYSTEM – BALCONY AWNING ITALIA Edition 7/ March 2022 / EN page 25 / 28...
-
Page 26: Complaint / Technical Defects
The application should contain a detailed description of the defect, the name of the company that installed the product and the date of finding the defect. Photo or video documentation in the event of the inability to deliver the claimed goods to SELT. ... -
Page 27: Marking And Labelling Of The Product With Ce Mark
10.1 PRODUCT COMPLIANCE WITH THE CE STANDARD Products manufactured by SELT company meet the essential requirements of the standard introduced by the Polish Committee for Standardization as PN-EN 13561 what is confirmed by the manufacturer’s declaration of performance and marking the product with the CE mark. - Page 28 Opole, ul. Wschodnia 23A POLAND Awning with hinged arms ITALIA 230V/ 50 Hz Power 198 to 250 W 02 / DZ/2017 DT-E 11.10 SUN PROTECTION SYSTEM – BALCONY AWNING ITALIA Edition 7/ March 2022 / EN page 28 / 28...
Need help?
Do you have a question about the ITALIA and is the answer not in the manual?
Questions and answers