Related Manuals for SELT ITALIA
Summary of Contents for SELT ITALIA
- Page 1 11.10 DT-E TECHNICAL AND OPERATIONAL DOCUMENTATION ASSEMBLY INSTRUCTIONS, OPERATION AND SAFE USE (original instructions) Awnings 11.10 Balcony awning ITALIA...
- Page 2 THIS TECHNICAL AND OPERATIONAL DOCUMENTATION: is valid from: 01 June 2024. applies to the product versions marked above. Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 10/ June 2024 / EN website 2 / 30...
-
Page 3: Table Of Contents
Assembly tools ..............................11 Assembly ................................11 4.5.1 Italia awning installation - wall brackets ..................... 11 4.5.2 Installation of Italia awning - installation of arm bracket in recess ............. 17 Electric drive ................................. 17 4.6.1 Connection to the electrical system ......................17 4.6.2 Control ................................. -
Page 4: Introduction
Risk to health or life through electric shock. Marking of electrical or electronic equipment subject to collection at designated ENVIRONMENT points. Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 10/ June 2024 / EN website 4 / 30... -
Page 5: Terms And Definitions
SELT will not be liable for damages resulting from failure to follow the recommendations in this documentation. In order to further improve the product, SELT reserves the right to make changes which, while maintaining the essential technical parameters, are deemed advisable to increase the quality of the product's handling and safety of use. -
Page 6: Technical Product Information
→ AUTOMATICS The optional use of weather automatics further protects the product from changing weather conditions. PRODUCT CHARACTERISTICS The products manufactured by SELT have excellent technical and performance characteristics. They are characterised by the following features: They provide excellent sun protection for areas such as terraces, balconies. -
Page 7: Construction Of The Italia Awning
CONSTRUCTION OF THE ITALIA AWNING Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 10/ June 2024 / EN website 7 / 30... -
Page 8: Transport And Storage Of Goods
COMPLETENESS AND QUALITY CONDITION OF THE DELIVERY SELT Sp. z o. o. makes every effort to ensure that the goods conform to the order. However, it is up to the Purchaser to check the completeness of the product and this should be done at the time of receipt. -
Page 9: Assembly Of The Product
This chapter contains the general requirements for the installation of the product. Correct assembly is a prerequisite for the smooth functioning of the product. SELT recommends the use of specialised installation teams, which guarantee the correct installation to the purchaser. -
Page 10: General Product Installation Guidelines
Incorrect installation can contribute to dangerous situations for the user. Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 10/ June 2024 / EN website 10 / 30... -
Page 11: Assembly Tools
4.5.1 MOUNTING OF THE ITALIA AWNING - WALL BRACKETS SELT recommends the use of Fischer fixing products - selected according to the type of substrate. Proposed recommendations for selected substrates: Wall and ceiling baffles for non-cracked concrete of class C20/25 and no higher than C50/60: ... - Page 12 Motor without emergency Motor with emergency retraction Plate with hole and screw M6x30 retraction (optional) Adapter Adapter Mounting (with protection) Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 10/ June 2024 / EN website 12 / 30...
- Page 13 (note for the motor, once it has clicked into place, the safety tube with round mandrel. catch must be engaged) Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 10/ June 2024 / EN website 13 / 30...
- Page 14 12) Remove the awning and drill the holes at the marked points. 13) Fix the mounting anchors. 14) Screw on the handle. Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 10/ June 2024 / EN website 14 / 30...
- Page 15 18) Slide the ends of the arms into the groove of the front beam one by one and secure them with screws. 19) Start assembling the arms by marking the attachment points of the arm brackets. Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 10/ June 2024 / EN website 15 / 30...
- Page 16 25) Fix the end of the arms with the front beam (tighten the bolt with square 26) Fasten the front beam caps with washer). screws. Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 10/ June 2024 / EN website 16 / 30...
-
Page 17: Installation Of Italia Awning - Installation Of Arm Bracket In Recess
Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 10/ June 2024 / EN website 17 / 30... -
Page 18: Control
When commissioning the awning, special attention should be paid to: correct unrolling and retraction of the awning with fabric, correct tripping of limit switches. Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 10/ June 2024 / EN website 18 / 30... -
Page 19: Manual Drive
- otherwise it will be permanently damaged. It is recommended that changes to the configuration of the fixtures are consulted with SELT. SAFETY REQUIREMENTS RELATED TO THE SPECIFIC CONDITIONS AND PLACES OF USE OF THE PRODUCT The special safety requirements apply, for children up to the age of 42 months. The special use requirements apply in all places where young children have access to or are likely to be. -
Page 20: Operating Safety
Automatically controlled products may start up on their own. Make sure that no dangerous situation arises. SELT Sp. z o.o. is not responsible for damage caused by improper use. Operating the system out of sight can cause serious injury as well as damage to the system Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA... -
Page 21: Control Of Safe Use Of The Product
The above-mentioned checks can be carried out by specialised installation groups with the appropriate qualifications. Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 10/ June 2024 / EN website 21 / 30... -
Page 22: Use And Maintenance Of The Product
Possible adjustment and improvement of the fixing of listed components. The products manufactured by SELT Sp. z o.o. do not require any special maintenance. The use of the product in accordance with the manufacturer's recommendations ensures long-term and fault-free operation of the system for the user. Ongoing maintenance work should be carried out on the maximally developed system. -
Page 23: Use Of Awning Fabrics
Due to the use of an impregnating agent, the fabric is sensitive to all kinds of scratches that are difficult to avoid even with a very precise and careful production process. This effect mainly affects single-colour fabrics. Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 10/ June 2024 / EN website 23 / 30... - Page 24 If a soggy fabric is rolled up, it should be unrolled immediately after the rain has stopped and allowed to dry. Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 10/ June 2024 / EN website 24 / 30...
-
Page 25: Exclusions From Liability
The general terms and conditions of guarantee are available at www.selt.com. In the absence of access to the SELT Sp. z o. o. website, the warranty conditions can be obtained from your SELT Sp. z o. o. sales representative. EXCLUSIONS FROM LIABILITY SELT Sp. - Page 26 SIDE Parallel reduction for Wired control via Confirmation of Emergen Built-in radio NAME GROUP COVER Mechanical connection gentle cassette switch radio signal ITALIA ITALIA SILVER receiver ITALIA MALTA AUSTRALIA JAMAICA PALLADIO CORSICA DAKAR CASABLANCA BORA end stops to control closing...
-
Page 27: Complaint/Technical Defects
Roll up the awning and take it out of service. immediately report the defect of the product to the competent specialized assembly team. Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 9 / January 2024 / EN website 27 / 30... -
Page 28: Disassembly / Disposal / Decommissioning Of The Product
2006 on batteries and accumulators and waste (Journal of Laws 2022, item 1113) batteries and accumulators and repealing Directive 91 / 157 / EEC Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 9 / January 2024 / EN website 28 / 30... -
Page 29: Ce Marking And Labelling Of The Product
10.1 CE CONFORMITY OF THE PRODUCT The products manufactured by SELT meet the essential requirements of the standard introduced by the Polish Committee for Standardisation as PN-EN 13561, which is confirmed by the manufacturer's declaration of functional properties and the CE mark. - Page 30 Opole, 23A Wschodnia St. POLAND Awning with pivoting arms ITALIA 230V/ 50 Hz Power 240 to 275 watts 02 / DZ/2017 Original instructions DT-E 11.10 SUNSHADE - BALCONY AWNING SYSTEM ITALIA Edition 9 / January 2024 / EN website 30 / 30...
Need help?
Do you have a question about the ITALIA and is the answer not in the manual?
Questions and answers