Separating The Product Into Two Modules Where Necessary - Vaillant uniTOWER plus Operating Instructions Manual

4.8.1 Using the carrying straps
1. Remove the front casing. (→ Section 4.10.1)
Danger!
Risk of injury due to repeated use of the
carrying straps.
Due to material ageing, the carrying straps
are not designed to be reused during any
subsequent transportation.
▶
Once the product has been started up, cut
off the carrying straps.
Caution.
Risk of damage caused by carrying
straps.
The carrying straps may damage the front
casing during transport.
▶
Remove the front casing before you use
the carrying straps.
2. To transport the unit safely, use the two carrying straps
on the two front feet of the product.
3. If the carrying straps are located underneath the
product, swivel these to the front.
4. Always transport the lower part of the product as
shown above.
24
5. Always transport the upper part of the product as
shown above.
4.9 Separating the product into two modules
where necessary
1. Remove the front casing. (→ Section 4.10.1)
2. Remove the side casing. (→ Section 4.10.2)
3. Move the electronics box into the maintenance posi-
tion. (→ Section 4.12)
36 mm
2
1
36 mm
4. Slide the heat insulation (2) on the pipe transitions up-
wards.
5. Unscrew the two nuts (1) on the pipe connections.
Note
Rear screwed connection has a left-hand
thread.
Installation and maintenance instructions 0020291525_04