F Installer Level Overview - Vaillant uniTOWER plus Operating Instructions Manual

F Installer level overview
Setting level
Installer level →
Enter code
Installer level → Fault list →
1)
F.XX – F.XX
Installer level → Test menu → Statistics →
Compressor hours
Compressor starts
Build. pump hours
Build. pump starts
4-port valve hours
4-port valve sw. ops
Fan 1 operating hours
Fan 1 starts
Fan 2 operating hours
Fan 2 starts
EEV steps
DHW PDV switch. ops
Im. heater power cons.
Im. heater op. hours
Im. heater switch. ops
No. switch. ops
Installer level → Test menu → Check programmes →
P.04 Heating mode
P.06 Purge building circuit
P.11 Cooling mode
P.12 De-icing
P.27 Immersion heater
P.29 High pressure
Installer level → Test menu → Sensor/actuator test →
T.0.01 Building circuit pump
power
T.0.17 Fan 1
T.0.18 Fan 2
T.0.19 Condensate tray heater
T.0.20 4-port valve
T.0.21 Position: EEV
T.0.23 Heating coil compressor
T.0.40 Flow temperature
T.0.41 Return temperature
T.0.42 Building circuit: Water
Pressure
1)
See the overview of fault codes: Fault lists are only available, and can only be deleted, if faults have occurred.
2)
This parameter does not appear if a system control is connected.
3)
This parameter is only available in the products for Spain
50
Values Unit
Min. Max.
00 99
Current value
Current value h
Current value
Current value h
Current value
Current value h
Current value
Current value h
Current value
Current value h
Current value
Current value
Current value
Current value kWh
Current value h
Current value
Current value
0 100 %
0 100 %
0 100 %
Off On
Off On
0 100 %
Off On
℃
-40 90
℃
-40 90
0 3 bar
Increment, select, ex- Factory setting
planation
1 (competent person 17
code 17)
Select
Select
Select
Select
Select
Select
5, off 0
5 0
5 0
On, Off Off
On, Off Off
5 0
On, Off Off
0.1
0.1
0.1
Installation and maintenance instructions 0020291525_04
Setting