Operation; Maintenance; Optional Accessories - Dolmar AG-3729 Instruction Manual

NOTE:
The battery overheat protection works only with a
battery cartridge with a star marking.
Fig.2
Overdischarge protection
Fig.3
When the remaining battery capacity gets low, the
battery indicator blinks on the applicable battery side.
By further use, the tool stops and the battery indicator
lights up about 10 seconds. In this situation, charge the
battery cartridge.
Switch action
Fig.4
To start the tool, simply press the "HIGH/LOW" button.
To switch off, press the "OFF" button. To change the
tool speed, press the "HIGH/LOW" button. The first
press on this button is for high speed and the second
press for low speed and then each press on this button
repeats the high/low speed cycle alternatively.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the long nozzle
Fig.5
To install the long nozzle, push in onto the blower outlet
of the tool all the way.
Fig.6
To remove the long nozzle, press its both buttons and
with the buttons being pressed pull it out.
Installing the shoulder strap
Fig.7
Pull the hanger out of the tool.
Hook the shoulder strap onto the hanger of the tool.
Before use, adjust the length of strap so that it is easy to
work with it.

OPERATION

Blowing
Fig.8
Hold the blower firmly with a hand and perform the
blowing operation by moving it around slowly.
When blowing around a building, a big stone or a
vehicle, direct the nozzle away from them.
When performing an operation in corner, start from the
corner and then move to wide area.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Cleaning
Fig.9
From time to time, wipe off the outside of the tool using
a cloth dampened in soapy water.
Replacing carbon brushes
Fig.10
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Fig.11
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by DOLMAR Authorized Service Centers,
always using DOLMAR replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Dolmar tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Dolmar service center.
Dolmar genuine battery and charger
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
6
or attachments
Only use accessory or
are