Affix The Protective Film; Adjust The Height And Slide The Dishwasher Into Place - Asko DBI644MIB.W/1 Operating Instructions Manual

Installation
WARNING!
A completely freestanding dishwasher must be fitted with anti-tip brackets.
C. Partially built-in
If the dishwasher is located so that one of its sides is visible, a side panel must be fitted. Accessories
can be purchased where you bought the dishwasher.

Affix the protective film

Affix the protective film (packed in the document bag). The protective film is to protect the worktop
from moisture.
NOTE!
The surface to which the protective film is affixed must be clean and dry.

Adjust the height and slide the dishwasher into place

1. Start by measuring the height from the floor to the bottom edge of the worktop.
2. Measure the height from the floor to the top edge of the dishwasher.
3. Lean the dishwasher forwards a little and adjust the rear foot with the screw at the front of the
dishwasher. Turn clockwise to lower or anticlockwise to raise.
40