Table of Contents
Advertisement
Installation
Transport protection for the door
Do not forget to remove the transport protection for the door when unpacking the dishwasher.
Placing the dishwasher
The dishwasher is intended for installation under a worktop. The recess dimensions are illustrated.
Holes for wires/cables need not be larger than 38 mm in diameter. Make sure the edges of such
holes are even to prevent damage to the drainage and inlet hoses and the power cable.
[mm]
If the dishwasher is built-in the surrounding cabinetry must be resistant to any condensation from
the dishwasher.
Accessory
Buy an accessory kit for freestanding installation (two side panels, a worktop and two anti-tip brackets).
If the dishwasher is placed so that one of the sides is visible, side panels must be fitted. If the
dishwasher is completely freestanding, both side panels, a worktop and anti-tip brackets must be
fitted. Accessories can be purchased from where you bought the dishwasher.
Affix the protective film
Mount the protective film beneath the worktop and up around the edge. The function of the protective
film is to protect the worktop from moisture. (The protective film is in the enclosed plastic bag.)
36
Advertisement
Table of Contents
