Advertisement
WorkHorse Monitor/Sentinel Deployment Guide
Connecting to the ADCP
C
O N N E C T I N G T O T H E
Using TRDI Toolz
Verify if the system is a WH or WHII
Connecting to the ADCP
To establish communications with the WorkHorse:
1. Connect the system and apply power.
2. Start the TRDI Toolz software.
3. Select New Serial Connection.
4. Enter the ADCP's communication settings. Select the COM Port
the serial cable is connected to and set the Baud Rate from the
drop-down lists.
5. Click the Connect button. Once connected, the button will change to Disconnect.
6. Click the Break (
select Soft Break (= = =). The wakeup banner will display in the terminal
window.
How do I know if I have WH or WHII electronics?
[BREAK Wakeup A]
Workhorse II Broadband ADCP Version 7x.xx
Teledyne RD Instruments (c) 1996-2022
All Rights Reserved.
>
The system has the Workhorse II electronics in-
stalled. Use the Workhorse II Plan software to
create a deployment command file.
A D C P
I N C L U D E S T H E F O L L O W I N G S T E P S
) button. From the Break button drop down menu,
EAR99 Technology Subject to Restrictions Contained on the Cover Page.
[BREAK Wakeup A]
WorkHorse Broadband ADCP Version 5x.xx
Teledyne RD Instruments (c) 1996-2010
All Rights Reserved.
>
The system has the original Workhorse electronics
installed. Use the PlanADCP software to create a
deployment command file.
P/N 957-6285-00 (July 2023)
:
Page 7
Advertisement
