Huawei SUN2000-100KTL-M2 User Manual page 88

SUN2000-(100KTL, 110KTL, 115KTL)-M2
User Manual
●
●
Procedure
1.
Issue 07 (2023-04-30)
b. The WLAN or Bluetooth function is enabled.
c. Keep the mobile phone within 5 m from the SUN2000. Otherwise, the
communication between them would be affected.
Connection over a Smart Dongle, ensure that:
a. The Smart Dongle is inserted into the USB port at the bottom of the
inverter.
b. The WLAN function is enabled on the phone.
c. The WLAN function is enabled on the Smart Dongle.
d. Keep the phone within 10 m of the Smart Dongle. Otherwise,
communication between them might fail. The distance is for reference
only and may vary with mobile phones and obstacles in-between.
Connection over a USB cable:
a. The USB data cable is connected from the USB port at the bottom of the
SUN2000 to the port on the mobile phone.
b. If the USB data cable is successfully connected, the message Connected
to USB Accessory will pop up on the phone. Otherwise, the cable is not
connected.
Run the app and select a connection mode.
NO TE
● The screenshots in this document correspond to the SUN2000 app 6.22.10.117
(Android) and FusionSolar app 6.22.10.117 (Android). The screenshots are for
reference only. The actual screens may vary.
● When the WLAN connection is used, scan the QR code of the WLAN module to
access the login screen.
● When the WLAN connection is used, the initial name of the WLAN hotspot is
Adapter-WLAN module SN, and the initial password is Changeme. Use the initial
password upon first power-on and change it immediately after login. To ensure
account security, change the password periodically and keep the new password in
mind. Not changing the initial password may cause password disclosure. A
password left unchanged for a long period of time may be stolen or cracked. If a
password is lost, devices cannot be accessed. In these cases, the user is liable for
any loss caused to the PV plant.
● When the Bluetooth connection is used, the connected Bluetooth device is named
after last 8 digits of the SN barcode+HWAPP.
● After you select Use by default for this USB accessory, a message that asks you
to confirm the USB access will not appear if you log in to the app again without
removing the USB data cable.
a. (Scenario in which the SUN2000 is connected to the FusionSolar hosting
cloud) Run the FusionSolar app and access the Device Commissioning
screen.
Copyright © Huawei Technologies Co., Ltd.
7 Man-Machine Interactions
81