Huawei SUN2000-100KTL-M2 User Manual page 105

SUN2000-(100KTL, 110KTL, 115KTL)-M2
User Manual
No. Parameter
23 Communication
disconnection
detection time (s)
24 Active power mode
when
communication
fails
25 Active power
threshold when
communication
fails (%)
26 Reactive power
mode when
communication
fails
27 Reactive power
threshold when
communication
fails
28 Closed-loop
controller
Issue 07 (2023-04-30)
Description
Specifies the fail-safe detection
time for the disconnection
between the inverter and the
SmartLogger or Smart Dongle.
Specifies the protection threshold
of the active power after
communication is interrupted.
The value can be a percentage or
a fixed value.
Specifies the active power
threshold in percentage.
Specifies the protection threshold
of the reactive power after
communication is interrupted,
including Q/S and power factor.
Specifies the Q/S threshold of the
reactive power.
● If multiple inverters are
cascaded, the Smart Dongle or
SmartLogger is connected, and
closed-loop scheduling is
enabled, set this parameter to
SDongle/SmartLogger.
● If there is only one inverter
and closed-loop scheduling is
enabled, set this parameter to
Inverter.
● If closed-loop scheduling is
disabled, retain the default
value.
Copyright © Huawei Technologies Co., Ltd.
7 Man-Machine Interactions
Remarks
This parameter is displayed
when Communication
disconnection fail-safe is set
to Enable.
This parameter is displayed
whenCommunication
disconnection fail-safe is set
to Enable and Active power
mode when communication
fails is set to a percentage.
This parameter is displayed
when Communication
disconnection fail-safe is set
to Enable.
This parameter is displayed
when Communication
disconnection fail-safe is set
to Enable and Reactive
power mode when
communication fails is set to
Power factor.
-
98