Table of Contents
Advertisement
Chapter 8. Troubleshooting
The Lenovo UPS is designed for durable, automatic operation. It will alert you whenever operating problems
occur. Usually the alarms shown by the control panel do not mean that the output power is affected. Instead,
they are preventive alarms intended to alert the user.
• Events are silent status information that are recorded in the Event log. Example = "AC freq in range".
• Alarms are recorded in the Event log and displayed on the LCD status screen with the logo blinking. Some
alarms are announced by a beep every 3 seconds. Example = "Battery low".
• Faults are announced by a continuous beep and red LED, recorded in the Fault log and displayed on the
LCD with a specific message box. Example: "Out. short circuit."
Use the following troubleshooting chart to interpret alarm conditions.
Alarms and faults
To check the Event log or Fault log:
1. Press any button on the front panel display to activate the menu options.
2. Press the
button to select Event log or Fault log.
3. Press Enter (
) to review the selected log.
4. Scroll through the listed events or faults.
The following table describes conditions that are logged..
Conditions
Online mode
Battery mode
LED is On.
1 beep every 10 seconds.
© Copyright Lenovo 2015, 2020
Possible cause
Normal operation.
A utility power failure has occurred, an
upstream circuit breaker is tripped, or the
input power cord (if so wired) is unplugged.
Action
None.
Check the input power source and
connections.
39
Advertisement
Table of Contents
