Advertisement
Quick Links
Maintenance Guide
To keep Roomba running at peak performance, it is recommended that you
perform the following maintenance tasks after every use:
1
Remove and empty Roomba's bin
a. Press the bin release tab and pull to
remove the bin.
b. Open the bin door to empty the bin.
600 Series
a.
Wi-Fi Connected 600 series
a.
600 series
b.
IMPORTANT INFORMATION
e & i Series
a.
b.
900 Series
a.
b.
Advertisement
Related Manuals for iRobot Roomba 600 Series Roomba e Series
Summary of Contents for iRobot Roomba 600 Series Roomba e Series
- Page 1 IMPORTANT INFORMATION Maintenance Guide To keep Roomba running at peak performance, it is recommended that you perform the following maintenance tasks after every use: Remove and empty Roomba’s bin e & i Series a. Press the bin release tab and pull to remove the bin.
- Page 2 Maintenance Guide 900 Series Clean Roomba’s filter compartment a. Pull the filter to remove. b. Shake off debris by tapping the filter against your trash container. c. Clean or replace filter. 600 Series e & i Series...
- Page 3 Maintenance Guide Clean Roomba’s side brush c. Spin the wheel by hand. If rotation is restricted, a. Use a coin or small screwdriver to remove wheel from its remove the screw. housing and push firmly b. Remove brush, clean the brush and to remove the axle and brush post, and reinstall the brush.
- Page 4 Maintenance Guide Clean Roomba’s charging contacts Clean base reporting a bag full after just a couple runs i series a. Clean the charging contacts by wiping the charging contacts on the home a. Lift up the lid of the canister lid to open. base and Robot with a clean, dry cloth.
- Page 5 Maintenance Guide Clear clogged Clean Base™ d. Place the Clean Base® Charging Station + Automatic Dirt Disposal Charging Station + Automatic Dirt on its side. Loosen the 5 screws Disposali series retaining the debris evacuation a. Push down the canister lid to ensure it tubing on the bottom and then remove is firmly sealed.
-
Page 6: Battery Information
Maintenance Guide Battery Information 16-Hour Refresh Charge If Roomba has been left off of the Home Before you use Roomba for Base for an extended period, it will automat- the first time, or when returned ically initiate a special 16-hour charge cycle. from service you may need to This extensive charge refreshes the battery activate Roomba by removing... - Page 7 Maintenance Guide Removing Roomba’s Battery e & i Series Undo screw and remove side spinning brush. Remove screws on base plate and set aside. Remove battery by lifting the pull tabs. 600 Series 900 Series...
- Page 8 Australia New Zealand Free Call: 1300 727 421 Free Call: 0800 727 421 E: customerservice@ixl.com.au E: service@ixlhome.co.nz...