Troubleshooting; Automatic Fault Warnings And What To Do - Bertazzoni Professional Series Installation Manual

TROUBLESHOOTING

FAULT
Rust stains have formed on the
dishes.
Detergent remains in the detergent
compartment.

AUTOMATIC FAULT WARNINGS AND WHAT TO DO

FAULT CODE
FF
F5
F3
F2
F8
F1
FE
F7
F9
F6
HI
42
POSSIBLE CAUSE
Stainless-steel quality of the dishes is
insufficient.
High level of salt in wash water.
Salt compartment cap not closed
properly.
Too much salt spilled in the
dishwasher while filling it with salt.
Poor mains grounding.
Detergent was added when the
detergent compartment was wet.
POSSIBLE FAULT
Water inlet system failure
Pressure system failure
Continuous water input
Inability to discharge water
Heater error
Overflow
Faulty electronic card
Overheating
Divisor position error
Faulty heater sensor
High voltage failure
TROUBLESHOOTING
Use only dishwasher-proof sets.
Adjust the water hardness level using
the water hardness table.
Check that the salt compartment cap
is closed properly.
Use funnel while filling compartment
with salt to avoid spillage.
Consult a qualified electrician
immediately.
Make sure detergent compartment is
dry before use.
WHAT TO DO
Make sure the water inlet tap is open
and water is flowing.
Separate the inlet hose from the tap
and clean the hose filter.
Contact service if the error continues.
Contact service.
Close the tap and contact service.
Water discharge hose and filters may
be clogged.
Cancel the program.
If the error continues, contact service.
Contact service.
Unplug the machine and close the tap.
Contact service.
Contact service.
Contact service.
Contact service.
Contact service.
Contact service.