Maytag Amana NDE2330AYW Service Manual page 44

TOPIC
Drying
Long drying times
Lint
Static
16023020
POSSIBLE CAUSE
Improper exhaust system
Overloading
Sorting
Full lint filter
Clothes too wet from washer
Full lint filter
Improper sorting
Paper, tissues, or other items left in pockets
Overloading
Overdrying
No fabric softener was used
Synthetic fabrics can cause static
Trouble Shooting
SOLUTION
Check Installation Instructions for length of proper exhaust
system. Only use 4" diameter rigid or semi-rigid duct.
Restricted airflow will cause dryer to stop heating. Check
weather hood and exhaust system for restrictions.
Dry one wash load at a time.
Separate heavy items from lightweight items.
Clean lint filter before each use.
Check that the washer had enough spin speed to extract
water. Clothes may need to be rearranged in the washer
and put through an additional spin cycle to extract enough
water before drying.
Clean lint filter before each use.
Separate lint producers (cotton towels) from lint attracters
(synthetic fabrics).
Remove items from pockets before washing or drying.
Overloading reduces airflow so lint is not collected in filter.
Dry one wash load at a time.
Adjust controls for shorter drying time. Use a fabric
softener.
Use a fabric softener.
Use a fabric softener.
A–12
(cont'd)