Back Panel Removal; Side Light Housing Removal; Hinge Receiver Removal - Viking RVGR3305B Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Back Panel Removal

1. Remove backguard assembly (see Backguard
Assembly Removal).
2. Remove screws and gas connection cover from
range.
3. Slide grommet and power cord from back panel.
4. Remove screws and back panel from range.
5. Reverse procedure for installation.

Side Light Housing Removal

1. Remove back panel (see Back Panel Removal).
2. Disconnect connector for side light housing.
©2013 Viking Preferred Service
3. Remove rack support (see Rack Support Removal).
4. Remove screw and side light housing from oven liner.
5. Reverse procedure for installation.

Hinge Receiver Removal

1. Remove side panel (see Side Panel Removal).
2. Remove screws and side trim from range.
3. Remove screws and panel from range.
4. Remove screws and hinge receiver from range.
5. Reverse procedure for installation.
Disassembly
31