Oven Function Selector Removal; Oven Thermostat Removal; Oven Light Switch Removal; Indicator Light Removal - Viking RVGR3305B Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Oven Function Selector Removal

1. Access control components (see Control
Components Accessed).
2. Disconnect connector from the oven function
selector.
3. Remove screws, bezel, and oven function selector
(always on left) from control panel.
4. Reverse procedure for installation.

Oven Thermostat Removal

1. Access control components (see Control
Components Accessed).
2. Disconnect connector from the oven thermostat
(always on right).
3. Remove screws, bezel, and thermostat from control
panel.
4. Reverse procedure for installation.
©2013 Viking Preferred Service

Oven Light Switch Removal

1. Access control components (see Control
Components Accessed).
2. Mark and disconnect connectors from light switch.
3. Remove screws and oven light switch from control
panel.
4. Reverse procedure for installation.

Indicator Light Removal

1. Access control components (see Control
Components Accessed).
2. Hold the blue lens and slide off the indicator light.
The indicator light will only slide in one direction.
3. Disconnect two connectors from the indicator light.
4. Reverse procedure for installation.
Disassembly
25