Control Panel Assembly Removal; Oven Function Selector Removal; Oven Thermostat Removal - Viking VISC530 Service Manual

Service Diagnostics and Procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless
test procedures require power to be connected. Discharge capacitor through a resistor before attempting
to service. Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Control Panel Assembly Removal

Condition Requirements:
Door Lowered
1. Open oven door and remove two screws from
control panel assembly.
2. Lift up on control panel assembly to disengage
from keyhole screws.
3. Rest control panel assembly on ledge.
4. Tilt control panel assembly forward and
disconnect wiring to remove from range (label
wiring and switch orientation before disassembly).
5. Reverse procedure for installation.
© 2009 Viking Preferred Service
Screws
WARNING

Oven Function Selector Removal

Condition Requirements:
Control Panel Assembly Removed
1. Remove oven fuction slector knob from control
panel assembly.
2. Disconnect connector from the oven function
selector.
3. Remove two screws, bezel, and the oven
function selector from the control panel
assembly.
4. Reverse procedure for installation.

Oven Thermostat Removal

Condition Requirements:
Control Panel Assembly Removed
1. Remove oven thermostat slector knob from
control panel assembly
2 Disconnect connector from the oven thermostat.
2. Remove two screws, bezel, and the oven
thermostat from the control panel assembly.
3. Reverse procedure for installation.
31