Roland MT-300S Owner's Manual page 71

Rerecording the Section Between Marker A and Marker B (A-Punch)
After first setting Marker A and Marker B to define the segment you want to record
over and setting the recording process to "Punch-In Recording," proceed with the
recording. The MT 300s goes into recording mode only between Marker A and Marker
B, allowing you to record over the section from Marker A to Marker B.
1.
When recording over only a certain part or parts, select such parts in
the 16-Track screen (p.64).
2.
Set Marker A at the beginning of the section you want to record over,
and set Marker B at the end of the section.
Place Marker A and Marker B by using the Bwd [
move the markers to the desired locations. Then, press the Marker [A] and [B] buttons
to set the markers.
3.
Pressing the Marker [A] button takes you to the point where Marker
A is set.
4.
Press the Bwd [
back to begin.
5.
Press the Rec [ ] button, turning on its indicator.
The MT 300s is put into record standby mode.
6.
If you are using the Track buttons in rerecording, press the Track but-
tons for those tracks you want to record over.
7.
Press the Play [ ] button.
After two measures of count sound, playback begins.
Recording begins at the point where Marker A is set.
Recording stops where Marker B is located, and the MT 300s reverts to playback only.
8.
When you press the Stop [ ] button, playback of the song ceases.
] button to move to the point where you want play-
Recording Functions
] button or Fwd [ ] button to
71