LG 55UR80 0PSB Series Service Manual page 36

■ LED Array disassemble
Connector(CNT)
(1) Disassemble the CNT form LED Array.
(2) Separate the LED Array from Cover Bottom.
(3) Remove the double tape form Cover Bottom.
* After removing LED array once, You should not use it again.
■ LED Array assemble
Step 1. Attach the Double Tape.
(1) Attach the double tape to the round hole on Cover Bottom embo.
(2) Remove the protect film of Double Tape with taking off the handler.
* Required LED Array Quantity : 7 EA
Step 2. Attach the LED Array on the double tape.
Round hole
(1) Attach LED Array to the round hole on Cover Bottom embo.
(2) Press LED Array on the surface of Cover Bottom.
(3) Connect the CNT to the LED Array.
* Finish the Attached LED Array (7ea)
double tape
handler
NG
OK
- 36 -
Copyright © LG Electronics Inc. All rights reserved.
Only for training and service purposes.
Pull to the
upside