LG 55UR80 0PSB Series Service Manual page 31

(17) Position the Reflector sheet
- Align the reflector with the reflector guide hole at 6ea locations on the center/bottom of the reflector and assemble two support
plates first.
(18-1) Fixing the Reflector Lens Hole
- Tighten the reflector hole to the lens in order of No. 1 → 2 → 3 → 4 in the figure below. (Use Card or nail to insert the reflector
sheet into the bottom of the lens.)
It is recommended to push the reflector sheet into the bottom of the lens using tools such as a card, as it may be difficult to
tighten when using nails
2 2 3
4 3 1
(18-2) Assembly of 16 Support Diffuser Plates
- Insert the Support DP into the Support DP Hole on the Cover Bottom and rotate it clockwise 45 degrees (total 16ea), After
assembly, the Support DP is vertical Position to the LCM.
(19) Assembly of Sheet (1 sheets) and Diffuser Plate
- Place 1 sheets + 1 Diffuser Plate on top of Cover Bottom
- Assemble the sheet shape (Chamfer) on the front left side of the SET.
Sheet 1ea+
Diffuser Plate1ea
The Left down
Chamfer
4
SET Front position
- 31 -
Using tools
Diffuser Plate: Chamfer
Copyright © LG Electronics Inc. All rights reserved.
Only for training and service purposes.
Using nails
Sheet: Chamfer